6
Examine the oven after unpacking.
Check for damage such as a misaligned
door, broken door or dent in the cavity.
If any damage is visible, DO NOT INSTALL,
and notify your dealer immediately.
Level, flat location.
Install the microwave oven on a level, flat surface.
Ventilation.
Do not block air vents. If they are blocked
during operation, the oven may overheat
and eventually cause a failure.
For proper ventilation, allow 3 inches of
space between oven top, sides, rear and
adjacent surfaces. The minimum height of
free space necessary above the top surface
of the oven is 100mm.
Away from radio and TV sets.
Poor television reception and radio
interference may result if the oven is located
close to a TV, radio, antenna, feeder, etc.
Place the oven as far from them as possible.
Away from heating appliances and water taps.
Keep the oven away from heat, steam or
splashing liquids. These things can
adversely affect oven wiring and contacts.
Power supply.
This microwave oven requires a power
supply of approximately 13 Amperes, 120
Volts, 60Hz and a grounded outlet.
A short power cord is provided to reduce the
risk of the user becoming entangled in or
tripping oven longer cord. Longer cord sets
or extension cords are available and may be
used if care to exercised.
If an extension cord is used, the marked
electrical rating of the cord should be at least as
great as the electrical rating of the oven. The
extension cord must be a grounding-type 3-wire
cord. The longer cord should be arranged so it
does not drape over the table top or counter
where children can pull on it or trip over it.
Turn the oven off before cleaning.
Keep the inside of the oven clean. When
food spatters or spilled liquids adhere to
oven walls, wipe with a damp cloth. Mild
detergent may be used if the oven gets very
dirty. The use of harsh detergent or
abrasives is not recommended.
The outside oven surface should be cleaned with
soap and water, rinsed and dried with a soft
cloth. To prevent damage to the operating parts
inside the oven, water should not be allowed to
seep into the ventilation openings.
If the Control Panel becomes wet, clean
with a soft, dry cloth. Do not use harsh
detergents or abrasives on Control Panel.
If steam accumulates inside or around the
outside of the oven door, wipe with a soft
cloth. This may occur when the microwave
oven is operated under high humidity
conditions and in no way indicates
malfunction of the unit.
It is occasionally necessary to remove the
glass tray for cleaning. Wash the tray in
warm sudsy water or in a dishwasher.
The roller guide and oven cavity floor
should be cleaned regularly to avoid
excessive noise. Simply wipe the bottom
surface of the oven with mild detergent
water or window cleaner and dry. The roller
guide may be washed in mild sudsy water.
INSTALLATION
CARE OF YOUR M.W.O
Glass Tray
Roller Guide