12
4. Method to reduce the gap between the door seal and the oven front surface.
(1) To reduce gap located on part A
• Loosen two screws on the stopper hinge top, and then
push the door to contact the door seal to the oven front
surface.
• Tighten two screws.
(2) To reduce gap located on part B
• Loosen two screws on the stopper hinge under, and
then push the door to contact the door seal to the oven
front surface.
• Tighten two screws.
A
B
NOTE :
A small gap may be acceptable if the microwave leakage does not exceed 4mW/cm
2
.
Содержание KOG-8A0R5S
Страница 5: ...4 EXTERNAL VIEW 1 OUTER DIMENSION 465 347 287 ...
Страница 26: ...25 WIRING DIAGRAM ...
Страница 28: ...27 Measure Point MP2 MP1 GND ...
Страница 31: ...30 2 P C B CIRCUIT DIAGRAM DMR 631FS b f g d c e a DM R 6 31 P ...