Daewoo KOC-984T, Руководство по обслуживанию, Страница: 15 / 36

15
DISASSEMBLY AND ASSEMBLY
9. Method to reduce the gap between the door seal and the oven front surface.
(1) To reduce gap located on part ‘A’
•
Loosen two screws on stopper hinge top, and then push
the door to contact the door seal to oven front surface.
•
Tighten two screws.
(2) To reduce gap located on part ‘B’
•
Loosen two screws on stopper hinge under, and then push
the door to contact the door seal to oven front surface.
•
Tighten two screws.
(3) To reduce gap located on part ‘C’
•
Loosen a screw on interlock switch assembly
located bottom of oven body.
•
Draw the interlock switch assembly inward as possible to engage with hook on the door bottom.
•
Tighten a screw.
(4) To reduce gap located on part ‘D’
•
Loosen a screw on interlock switch assembly located top of oven body.
•
Following steps are same as step (3).
S m all gap m ay be acceptable if the m icrow ave leakage does not exceed 1m W /cm
2
.
NOTE
T he door on a m icrow ave oven is designed to act as an electronic seal preventing the leakage of m icrowave energy
from the oven cavity during the cook cycle. T his function does not require that the door be air-tight, m oisture (conden-
sation) Tight or light-tight. T herefore, the occasional appearance of m oisture, light or the sensing of gentle warm air
m ovem ent around the oven door is not abnorm al and do not of them selves, indicate a leakage of m icrow ave energy
from the oven cavity. If such w ere the case, your oven could not be equipped w ith a bent, the very purpose of which
is to exhaust the vapor-laden air from the oven cavity.
NOTE