23
CAUSE
REMEDY
(TROUBLE 7)
When “ERROR 2 ERROR 3” come on display.
CONDITION
CHECK
Check continuity of thermistor
(resistance of thermistor)
Defective
thermistor
RESULT
0
Ω
or infinite
Replace
“ERROR 2 &
ERROR 3”
come on
display
Check continuity of heater
(convection, upper, lower)
Defective touch
control circuit
Replace
Approx
200k~300k
Ω
(room
temperature)
Defective
heater
No
continuty
continuity
Replace
CONDITION
CHECK
Check each button for
continuity of the button
Malfunction of sub
pcb assembly
RESULT
Normal
CAUSE
REMEDY
Replace sub
pcb assembly
Display does
not show
programming
at all, even if
keyboard is
touched.
(TROUBLE 6)
The following visual conditions indicate a probable defective touch control Circuit or button P.C.B. assembly
1. Incomplete segments.
1) segment missing
2) partial segments missing
3) digit flickering other than normal fluorescent slight flickering
2. A distinct change in the brightness of one or more numbers exists in the
display
3. One or more digits in the display are not on when they should be.
4. Display does not count down or up with time cooking or clock operation.
5. Oven is programmable and cooks normally but no display shows.
6. Display obviously jumps in time while counting down.
7. Display counts down noticeably too fast while cooking.
8. Display does not show the time of day when clear button is touched.
9.Oven lamp and turn table motor do not stop although cooking is finished.
Check if the RELAY(RY4)contacts close and if they are close,replace touch control circuit.
