Daewoo FRS-T20FAN, Руководство по обслуживанию

Страница: 6 / 10

Proper use of refrigerator Proper use of refrigerator
[Way to replace the filter]
1.The filter installed in this refrigeratory is refined by NSF42, which can filter the
smell, chlorine and so on in running water.
2.The replacement cycle of the filter is about 6 mouths. When replacement is
needed, the indicator on the display board will turn on. The replacement cycle
may be shortened according to operating environment.
3.With the function of BY-PASS, it can supply water normally without the filter. If
necessary, additional filter can be installed and used out of the refrigeratory
by yourself.
4.During replacement, little water in the connection part may drop out, a container
can be located under it to receive the drops.
5.The filter is installed in the liner of the refrigerator. You can seize the lower bugle
and whirl it leftward to take it out. When it is difficult to take out, you can
detach the lampshade in the refrigerator before detaching the filter.
6.The assembling is in opposite order. Push it upwards and whirl it rightward at the
same time.
Operating instruction for the display and control panel
6
7
Button setting
When power-on, the refrigeratory will operate in the intelligent mode. The system
automatically sets the refrigerator temperature at 5
℃
,and that of the freezer at -
18
℃
.
Refrigerator temperature setting
Function:
A. Set the temperature of the refrigerator in the following range: 02
℃
- 08
℃
.
1
℃
changes every time of pushing.
B. Achieve the turn-on and turn-off of the refrigerator.
Operation:
Temperature adjusting: push the button
“
REF.TEMP.
”
, and the icon of the
refrigerator flashes. And push the button once again, to adjust the temperature
(the cycle of the adjustment order is 08-02-08), and the setting comes into effect
after 5 seconds.
B.Operation of automatic ice maker
1.Automatic ice maker operates when the freezer reaches the needed temperature
below 0 ℃ after a period prescriptive time when the refrigeratory is energized.
Under normal temperature, the time between the refrigeratory's first energizing
and first making of ice is about 6 hours.
2.The ice firstly made after the installation of the refrigeratory shall be thrown away
because of plastic smell and impurities.
3.The time interval of ice making is about 2 hours, and the amount of the ice is
different according to different service conditions.
4.When the ice storage is full, the ice maker will stop automatically, and when the ice
storage is empty, the ice maker will make ice again automatically.
5.The noises for de-icing, motor operation, dropping of ice into the ice storage, and
operation of water supply valve may not happen periodically. They are not errors.
6.Please use the button on/off on the distributor to turn off the ice-making function
when it is not required. The ice maker is sold under ON state. If unnecessary,
please turn off this function timely after installation of the refrigeratory. When the
ice-making function is turned on without connection of waterways, there are
operational noises of water supply valve.
7.When ice piece is smaller than usual in a certain period of time, please verify the
replacement frequency of the filter. When the filter reaches its operation time,
the water supply pressure is lower and the made ice piece is smaller.
8.When cleaning the ice storage box, turn off the ice-making function on the
distributor before detaching the ice storage box.
9.Do not whirl the Auger during reinstallation of the removed ice storage box. After
being whirled, the Auger cannot be assembled and installed normally. It may be
damaged when taking out the ice. Whirl the Auger left and right after it has been
whirled to ensure normal installation.
C.Supply of ice
1.Choose the ice/ water button on the display
board, select entire or crushed ice pieces and
make sure the relevant indicator turns on.
2.Use the container to push and hold the switch
plate to get ice.
3.According to the water supply condition, some
mixed small ice pieces may come out when getting
the entire ice pieces..
4.When crushed ice pieces are required, please
press the container most close to the ice discharging
orifice to prevent the crushed ice from dropping out.
5.When getting ice, the noises of motor, crushing ice
and so on are normal.
6.To protect the motor, the refrigeratory will stop when
the switch plate is pushed for 1 minute or more. Then,
releasing the switch plate and waiting a moment, you
can get ice normally again. When large amount of
entire ice pieces are required, please open the door
Of freezer, take the ice storage box out and use the ice in it.