9
Water tube
Water
Connector
Tap
4. Attach the Filter Box
1) Screw and fasten the filter holder to the left/right side
of the back of refrigerator.
In case the holder is not fastened well, remove
↜
the back paper of the tape on the filter holder and
attach it.
2) Insert the filter box into the holder.
5. Connect the Water Tube to the refrigerator.
1) Remove the rear cover at the bottom back of the
refrigerator.
2) Insert the fastening ring into the Water tube. (Be
careful to follow the direction of the nut.)
3) Insert the Water Tube into the top of the water valve,
turn the nut clockwise to fasten it. (The water valve is
to the right of the motors.)
4) Check for any bent tubes or water leaks; if so,
recheck installation procedure.
5) Replace the rear cover. (The water tube should be
placed between the groove of the refrigerator back
and motor cover.)
Water tube
Water tube
Water valve
Nut
Set the tube upright as the figure shows.
6. Fasten the Water Tube.
1) Fasten the Water Tube with the [Fastener A] .
2) Check if the tube is bent or sqeezed. If so, set it right
to prevent any water leak.
Water tube
Fastener A
7. After installation of Water Supply System
1) Plug in the refrigerator, press the [WATER] button on
the control panel for 2~3 minutes to remove any air
(bubble) in the pipes and drain out the initial water.
2) Check for the water leaks again through the water
supply system (tubes, connectors and pipes)
Rearrange the tubes again and do not move the
refrigerator.
Water tube
Tap
Connector
Information concerning the water filter
- After use, the water system is subject to low pressure.
Proceed with caution when removing the filter.
- Flush the water system if the appliance has not been in
use for a long period of time, or if the ice/water has an
unpleasant taste or smell. To do this, dispense water
through the water dispenser for several minutes.
If the unpleasant taste or smell remains, replace the
filter.
- Protect from frost: remove the filter cartridge if you
expect the temperature to drop below freezing.
- If pressure surges could occur in the water pipe, do
not install the water filter without a suitable surge
eliminator.
Contact an installation expert if you are not sure
whether pressure surges could occur in the water pipe.
- After installing a new filter:
Discard any ice produced in the first 24 hours after
switching on.
- If no ice has been removed for a long period of time,
empty the ice box and discard any ice produced over
the next 24 hours.
