METHODS OF SAFE INSTALLATION
1. SAFE INSTALLATION PLACE FOR YOUR REFRIGERATOR
4
•
Place the refrigerator on
hard and level floor.
NO
NO
•
Place your refrigerator
where there is no heat
source nearby.
High surrounding
temperature will lower
cooling efficiency and
increases your electricity
bill.
•
Place the refrigerator in
an area with low
moisture.
Splashing water or a
high moisture area may
cause a short circuit and
make rusting easier.
•
Avoid places that are
exposed to smoke.
The discoloring can
occur to the refrigerator.
At least 15cm
At least 15cm
At least 30cm
Carpet
Wooden Board,
Rubber Mat
•
For good ventilation
place refrigerator with
the spaced specified on
the figure.
This helps cooling
efficiency and lowers the
electricity bill.
•
Placing the refrigerator
on the carpet may cause
heat to develop and
discolor the appliance. In
such a case put a hard
wooden board or a
rubber mat between the
refrigerator and the
carpet.
3
The control has three settings from Low to
HIGH.
The control has three settings from Low to
HIGH.
Temperature is controlled by thermostat automatically. The Temperature Control inside
the refrigerator controls the degree of cooling for each compartment.
1. TEMPERATURE CONTROL
To turn off the refrigerator
NOTE: During spells of hot, humid weather and in rainy season, moisture
may develop on the cabinet, just as water condenses around
a cold glass of water. It is not an abnormal condition; wipe off the
moisture with a dry cloth. This can also happen when the refrigerator
is not installed in an appropriate place.
1. Clean the refrigerator thoroughly. Wipe the outside with a dry cloth, and the inside
with a damp cloth.
2. Set the temperature control knob at MIDDLE position.
3. Connect the power supply cord.
Disconnect the power supply cord. Remove icing case and food. Leave doors ajar for
ventilation and dehumidification of both compartments.
Freezer Temperature Control
Refrigerator Temperature Control
With the Refrigerating System in operation, it is likely that the cabinet will feel warm at the
front edges and sides. This does not indicate trouble.
It is due to the hot-line used in this type of Refrigerating System which consists of piping hot
gas from the (motor-driven) compressor along the front edges, the sides of the cabinet and
the center partition to prevent dewing. This has nothing to do with the storage temperature
inside. (The thick line indicates the hot-line)
2. RADIANT HEAT?
HOW TO OPERATE
Starting your new refrigerator
LOW
MID
HIGH
LOW
MID
HIGH
