Daewoo DWF-H361ARA, Руководство по обслуживанию, Страница: 5 / 36

3. DIRECTIONS FOR INSTALLATION AND USE
4 DIRECTIONS
The openings must not
be obstructed by carpet-
ing when the washing
machine is installed on a
carpeted floor.
⏿ ⏿
How To Install On An Inclined Place
ᵄ The place where it would be exposed to
direct sunlight.
ᵄ
The place nearby a heater or heat
appliance.
ᵄ The place where it would be supposed
to be frozen in winter.
ᵄ
The kitchen with coal gas and a damp
place like a bathroom.
NOTES
10Cm
Install the washer on a horizontal
solid floor. If the washer is installed
on an unsuitable floor, it could make
considerable noise and vibration.
INSTALLING PLACE
Never install in these places
2 Check the Horizon
Status
Check the position of tub above
the center of the washer.
1 Horizon
Setting
After controlling the height
by turning the adjustable
leg, let the washer put
down to the ground.
Keep the machine body
more than
25cm(9.85inches) apart
from the wall surface. It will
make easy cleaning the
drain filter which is equipped
at the back side of it. And if
it comes into contract
vibration may occur.
25cm(9.85inches)
⏿ ⏿
How to Connect the Inlet Hose
Be careful not to mistake in supplying between the hot(maximum : 50 ˚ C) and cold water.
In using only one water tap or in case of attached one water inlet valve, connect the inlet hose to the cold water inlet valve.
Do not over tighten : this could cause damage to couplings.
FOR SCREW-SHAPED TAP
3
Insert the inlet hose adapter
into the water inlet of a washer
and turn it to be fixed.
• Check the packing in the inlet
1
Connect the inlet
hose to the water tap
by screwing the
connector D tightly.
2
Connect the
connector-inlet
supplied if necessary.
Connector D
Rubber
Packing
Inlet Hose Connector C
Connector
Inlet
Rubber
Packing
Inlet Hose
Connector C
Connector D