Daewoo DWF-270G, Руководство по обслуживанию

Страница: 6 / 32

5
CONNECTION
HOW TO CONNECT THE INLET HOSE
Water faucet,suitable
Water faucet,not suitable
It is required that the front end shall be longer than 10cm.
The outlet end surface of the faucet shall be flat and smooth. If not please file it to avoid leakage.
2. Loosen the screw till the water faucet can be accessed. Put the jointer of the water inlet hose on the
faucet. See to Figure 2. (If the faucet is too large and the jointer can not be set on the water faucet,
please loosen the four screws and take out the bushing in the jointer. See to the figure.)
1. Press the lower end of the lock lever and push down the slider. Take off the water inlet hose jointer from
the water inlet hose component. See to Figure 1.
Remarks: Before installation, the threading is 4mm above the upper surface of the nut. After installation, the threading
is 2mm above the upper surface of the nut. See to Figure 6.
4. Take off the nameplate. Twist the fastening nut as per the indication of the figure to
seal up the outlet end surface of the faucet. See to Figure 5.
3. Fasten the four screws evenly. See to Figure 4.
>10mm
Outlet end surface
Nut
About 4mm before twisting
About below 2mm after twisting
Figure 5
Figure 1
Figure 4
Figure 6
Slider
Water inlet pipe jointer
Water inlet pipe
Locking lever
Confirm the water faucet
Connection between the water inlet hose jointer and the water faucet
Screwdriver
Mark label
Figure 2
Screw
Liner
Figure 3
Connection between the water inlet hose and the washing machine
1.Do not take off the water absorption cushion. Please check if
the cushion is dropped or damaged before each usage.
If it happens please contact our after-sale department immediately.
2.Put the nut of the water inlet hose on the valve jointer.
3.Fasten the nut. Swing it gently to confirm if it's suitable.
Water absorption cushion
Nut of the water inlet hose
Jointer of the water inlet valve
Connection between the jointer of the water inlet hose and the
water inlet hose
Slider Locking lever
Jointer of the water inlet hose
1.Push down the slider. Insert the water inlet hose into the jointer.
2.Hang the lock lever to the jointer.Release the slider till a click
sound is heard.
Locking lever
Slider
Dismantle the water inlet hose
1.Close the water faucet.
2.Press the locking lever. Push down the slider. Then pull of the water
inlet hose. If the machine is used more than once every week, the
jointer of the water inlet hose can be kept on the faucet to prevent
damaging the fixing screw.