4
;
;
;
INSTALLATION
■
LOCATION & ENVIRONMENT
Leave some space.
Space at least 10cm between the washer and the wall.
Place washer on a sturdy and flat surface.
If the washer is placed on an uneven or weak surface,
noise or vibration may be occurred.
(Allowable inclination is max. 2°)
Never install the washer near water.
Do not place the washer in steamy rooms or where the
washer is directly exposed to rain.
Moisture may destroy the electrical insulation and cause
an electric shock hazard.
Avoid direct sunlight or heating devices.
As plastic and electrical components are affected by direct
heat, never place the washer near heater, boilers, etc..
Do not place it under direct sunlight.
Avoid cold place.
Do not place or store the washer below 0°C(32°F) to avoid
any damage from freezing.
■
INLET HOSE SETTING
Attach the water inlet hose to the water inlet located near
WATER GUIDE KNOB.
■
DRAIN HOSE SETTING
!
Connect the drain hose to the drain outlet at the rear
side of your washer.
@
The other end of drain hose setting toward the bath
or sinkhole.
#
Install the drain hose under 85cm from the ground.
(In case DRAIN PUMP model)
85Cm
Less than 10cm
(NO DRAIN PUMP)
(PUMP)
;
;
;
CLEANING & MAINTENANCE
■
CLEANING THE LINT FILTER
If the dregs are piled up in the lint filter after finishing the
wash, push down and pull it out as shown in figure.
■
CLEANING THE DRAIN FILTER
In case of incomplete drain, remove the lint from the drain
filter with soft brush.
■
CLEANING THE OVER FLOW FILTER
Insert your fingers into the hole “A”
and then full the overflow filter
in the direction of arrow as shown
in the figure.
■
CLEANING THE WASH TUB
Fill water in the wash tub to “L” level,
then drain water from the wash tub
simultaneously with operating wash
cycle for 1~2 minutes.
Close the wash tub lid.
■
CLEANING THE WASHER BODY
Wipe of stains on the base and the control panel with soft
cloth.
Do not use benzene, thinner, cleanser or wax.
(Painted surface or plastic parts will be damaged.)
Proper care of your washer can extend its life.
A
