Specifications
System
VHS
Video signal
NTSC color
Channel coverage
VHF Channel 2-13
UHF Channel 14-69
CATV Channels A1-A5, A8, A-W,
W+1-W+84
VHF output signal
Channel 3 or 4 (selectable)
Video
Input: Video line in
Phono-type connector 1.0V (p-p)
75 ohms unbalanced, sync.negative
Output: Video line out
Phono-type connector 1.0V (p-p)
75 ohms unbalanced, sync.negative
Signal to noise ratio
More than 43dB (SP)
Horizontal resolution
220 lines
Audio
Input: Audio line in
Phono-type connector more than 47K
ohms
-8.8 dBm, unbalanced
Output: Audio line out
Phono-type connector less than 1.5K
ohms
-7.8 dBm , unbalanced
Frequency response
Normal: 100Hz-l0KHz (SP)
Signal to noise ratio
Normal: more than 40 dB
Audio distortion
Normal: less than 3% (SP)
Tape transport
Tape width
12.65 mm (1/2”)
Tape speed
SP: 33.35 mm/sec
EP: 11.12 mm/sec
Maximum recording time 480 min, with T-160 tape (EP)
Rewind/fast forward time
Approx 3 min (T-120 tape)
General
Power requirements
120 V, 60 Hz AC only
Power consumption
17 W
Dimensions
Set size (W x H x D)
14.17 x 3.54 x 10.78 inches
Carton size (W x H x D)
18.07 x7.67 x 14.13 inches
Weight (gross)
10.1 pounds
Daewoo Video Cassette Recorder User’s Guide
34
33
side of the remote sensor centre and no more than
23 feet from the VCR.
•
Make sure there is no obstruction between the
remote control and the VCR.
Timer clock does not work.
•
Make sure the VCR is plugged in and receiving
power.
•
If the unit has been without power for some period
of time, you must reset the clock and all your timer
programs.
Video cassette won’t go into the cassette
compartment.
•
Make sure there is not a tape already loaded into the
cassette compartment.
•
Insert the video cassette with the label side up.
VCR and remote control buttons don’t work.
The REW button does not work at the very beginning of a
video cassette. The FF, PLAY and REC/OTR buttons do not
work at the end of a video cassette.
Emergency indicator is blinking.
Press POWER to stop the indicator from blinking. If the
emergency indicator continues to blink, contact a service
technician.
The VCR buzzes when it is on.
The VCR may be in standby mode and the motor is
running. This sound is normal.
Video cassette recorder doesn’t rewind all the way
to the end.
To avoid video cassette tape damage, the VCR stops
rewinding near the end of the tape and then slowly
finishes rewinding. Do not prematurely eject the tape.
Daewoo Video Cassette Recorder User’s Guide
