RUN AND CHECK UP
2
Before the installation is carried out completely, check these out.
• Pipe connection and gas leaks
• Electric wiring and isolation treatment of drain pipes
• Drainage system and insulation treatment of drain pipes
• Grounding wire connection
Wire Remote Controller
1. Turn on the air conditioner. (If you can see the present temperature on the LCD of the wire remote controller, it means
the power supply is correctly connected.)
2. Set the mode 'Auto' and check if the outdoor unit is working properly.
(The outdoor unit runs 30 seconds after the first operation.)
3. Press the Fan Dir. button and check if regulating the angle of Flap is normal.
4. Complete the operation.
If any error occurs, ERR is shown on the wire remote controller.
Wireless Remote Controller
1. Turn on the air conditioner.(If you can see the present temperature on the LCD of the wire remote controller, it means
the power supply is correctly connected.)
2. Set the mode 'Auto' and check if the outdoor unit is working properly.(The outdoor unit runs 30 seconds after the first
operation.)
3. Complete the operation.
