Daewoo DSJ-6000LN, Руководство по обслуживанию

Страница: 3 / 39

- 2 -
1. Safety precautions
CAUTION : Do not attempt to modify this product in any way. Unauthorized
modifications will not only void the warranty, but may lead to your being liable for any resulting property damage or
user injury.
Service work should be performed only after you are thoroughly familiar with all of the following safety checks and
servicing guide-lines. To do otherwise, increases the risk of potential hazards and
injury to the user.
SAFETY CHECKS
After the original service problem has been corrected, a check should be made of the following:
SUBJECT : FIRE & SHOCK HAZARD
1. Be sure that all components are positioned in such a way as to avoid possibility of adjacent component shorts. This
is especially important on those chassis which are transported to and from the repair shop.
2. Never release a repair unless all protective devices such as insulators, barriers, covers, shields, strain relief, and
other hardware have been reinstalled per original design.
3. Soldering must be inspected to discover possible cold solder joints, frayed leads, damaged insulation (including
A.C. cord), solder splashes or sharp solder points. Be certain to remove all loose foreign particals.
4. Check for physical evidence of damage or deterioration to parts and components, and replace if necessary follow
original layout, lead length and dress.
5. No leads or components should touch a receiving tube or a resistor rated at 1 watt or more. Lead tension around
protruding metal surfaces must be avoided.
6. All critical components such as fuses, flameproof resistors, capacitors, etc. must be replaced with exact factory
types. Do not use replacement components other than those specified or make unrecommended circuit modifications.
7. After re-assembly of the set always perform an A.C. leakage test on all exposed metallic parts of the cabinet, (the
channel selector knob, antenna terminals, handle and screws) to be sure the set is safe to operate without danger of
electrical shock. Do not use a line isolation transformer during this test. Use an A.C. voltmeter, having 5000 ohms per
volt or more sensitivity, in the following manner : connect a 1500 ohm 10 watt resistor, paralleled by a 15 mfd. 150V
A.C. type capacitor between a known good earth ground (9water pipe, conduit, etc.) and the exposed metallic parts,
one at a time. Measure the A.C. voltage across the combination of 1500 ohm resistor and 0.15 MFD capacitor.
Reverse the A.C. plug
and repeat A.C. voltage measurements for each exposed metallic part. Voltage measured must not exceed 0.75 volts
R.M.S. This corresponds to 0.5 milliamp A.C. Any value exceeding this limit constitutes a potential shock hazard and
must be corrected immediately.