Daewoo DLT-19L1T, Инструкция по эксплуатации

Страница: 33 / 50

33
OK EXIT
OK EXIT
OK EXIT
OK EXIT
OK
EXIT
System Parameters
System Information Access
Factory Settings Access
Software Upgrade Access
Select Access Return Exit
System Information
Device iDTV5105 Plug-in
Software version UK no YUV
Hardware Model ST5105
Hardware Version V2.1
Software 1 Release v0.05
Access Return Exit
Re-installation confirmation
All private settings and other user data
will be erased.
Do you want to proceed?
Yes
Select Access Return Exit
Select Access Return
Select Access Return Exit
Time Settings
Date and Time 01/01/2007 00:26
Mode Auto
Signal Information
Channel 05
Frequency 178.750
Level
Quality
How To Install and Use
DVB (Digital Video
Broadcasts)
SYSTEM PARAMETERS
Using the “ / ” buttons to select the system parameters item and
press “
OK
” button to enter each item.
- System Information
You can see the system information but you cannot modify anything
in this menu. Press the “
OK ” or “ MENU ” button to return to System Pa-
rameters menu.
- Factory settings
If you want to restore all data to initial factory condition, select this
option. When you enter this menu a warning message will ask you to
proceed or not. Please note that if you proceed, all private settings and
other user data will be erased.
- Software Upgrade
Select the Software Upgrade item and press the “ OK ” button to enter
the Software Upgrade menu.
And then press the “
OK ” button to upgrade software. If there is new
software, the unit will upgrade itself.
Using the “
/ ” buttons to highlight the system parameters item in
the configuration menu, then press the “ OK ” button to display the sys-
tem parameters menu.
TIME SETTINGS (option)
In this menu you can set time two ways - Auto or Manual .
If you select Auto, time will be automatically set by broadcasting sig-
nal. In this option time can be different than real time if you receive
broadcasts from a different time zone.
If you select Manual, you can set time by yourself.
SIGNAL INFORMATION
Select Signal Information item and press the “ OK ” button. Cycle through
the channel option by using the “ / ” buttons on the remote con-
trol. The signal level and signal quality can be observed on the two bar
graphs. The bar graphs of signal quality and signal level give a good
indication of whether the selected channel is likely to be found. If the
signal quality bar is high then a digital frequency and digital channels
will probably be found.