Daewoo DATM80110, Руководство пользователя

Страница: 50 / 64

www.daewoopower.bg
50
За да регулирате обтягането, разхлабете четирите монтажни болта на двигателя и затягащия болт на стойката на
двигателя и движете двигателя напред или назад, за да достигнете правилното обтягане на ремъка.
Забележка: след регулиране се уверете, че външната страна на задвижващата шайба е изравнена с външната
страна на водещата ролка, като използвате тръбен ключ.
21
10. TRANSPORTING /STORAGE
WARNING:
When transporting the tiller, turn the fuel valve OFF and keep the tiller level to prevent
fuel spillage. Fuel vapor or spilled fuel may be ignited.
Before storing the unit for an extended period:
1. Be sure the storage area is free of excessive humidity and dust.
2. Drain the fuel.
WARNING: Gasoline is highly flammable and explosive under certain conditions. Do not smoke or
allow flames or sparks in the area.
• With the fuel valve turned OFF, remove and empty the fuel strainer cup.
• Turn the fuel valve ON and drain the gasoline in the fuel tank into a suitable container.
• Replace the fuel strainer cup and tighten securely.
• Drain the carburetor by loosening the drain knob. Drain the gasoline into a suitable container.
(1)O-RING
(2)FUEL STRAINER CUP
(3)DRAIN KNOB
3. Pull the starter grip until resistance is felt. Continue pulling until the notch on the starter puller
aligns with the hole on the recoil starter. At this point, the intake and exhaust valves are closed and
this will help to protect the engine from internal corrosion.
(1) Монтиращи болтове на двигателя
(2) Затягащ болт на двигателя
Разхлабете стоперите (водачите) на ремъка.
Регулирайте разстоянието между стоперите на ремъка и ремъка.
20
7. Belt Tension Adjustment
Adjust the clutch lever free play
The standard belt tension is 60-65 mm (2.4-2.6 in) at the tension roller with the clutch engaged
(clutch lever is squeezed).
To adjust, loosen the four engine mounting bolts and the engine stay tightening bolt and move the
engine forward or reverse to get proper tension of the belt.
NOTE:
After adjusting the tension, make sure that the outside face of the drive pulley is flush with
the outside face of the driven pulley by using a straight gauge.
(1) ENGINE MOUNTING BOLTS
(2) ENGINE STAY TIGHTENING BOLE
Loosen the belt stopper attaching bolts.
Adjust the clearance between the belt stopper and the belt as illustrated with the clutch lever
squeezed.
(1) BELT STOPPERS
(1) Стопери (водачи на ремъка)
BG