2
EN
NOTE:
If protection against high speed particles at extreme temperatures is required then the
selected face shield should be marked with the letter T immediately after the impact letter, i.e. FT,
BT or AT. If the impact letter is not followed by the letter T then the face shield shall only be used
against high speed particles at room temperature.
WASTE MANAGEMENT:
Please refer to local legislations for the proper disposal of packaging
waste, as well as disposal of this product after discontinued service.
The visors are mainly designed for forestry and industry work. It provides an essential impact
protection to the worker’s face.
The materials used in these visors do not contain any substances known to cause allergic reactions.
However, it may be possible for certain susceptible individuals to develop allergies to the material
used.
1. CLEANING AND DISINFECTION
Clean and disinfect only by soft cloth with mild soap and warm water. Solvent or abrasive cleaners
should not be used.
STORAGE
Ideally at 23°C, 55 RH.
SHELL LIFE: 1 year.
REPLACEMENT OF VISOR
Inspect frequently and replace the damaged visors.
MARKING
DAEWOO: Manufacturer identification
EN 1731: Number of European standard
F: Protection against high speed particles, low energy impact
S: Increased robustness
2. ADJUSTING
1. Set the top string.
2. Fasten the turnbuckle on the back.
3. Fasten the bolts on both sides to suitable tightness.
4. Adjust the positioner(4 positions) on both sides to secure the suitable position for the user.
WARNING (DAFS01)
1. The face shield against high speed particles worn over ophthalmic spectacles may transmit
impacts, this creating a hazard to the wearer.
2. The face shield does not protect against liquid splash, hot solids, electrical hazards, IR or UV
radiation.
3. The face shield marked “S” should not be used when there is a foreseeable risk of any hard or
sharp particles.
WARNING (DAFS02)
1. The face shield against high speed particles worn over ophthalmic spectacles may transmit
impacts, this creating a hazard to the wearer.
2. The face shield does not protect against hot solids, electrical hazards, IR or UV radiation.
3. The face shield marked “S” should not be used when there is a foreseeable risk of any hard or
sharp particles.