Manufactured under license of
Daewoo International Corporation
, Korea
www.daewoopowerproducts.com
USER'S MANUAL
DA
5100
-
HC
Hydraulic Hose Crimping Machine
Clockwise rotation is the correct direction, as shown by the red arrow in the figure.
If you find that the motor does not rotate clockwise, please change the connection of A and B, or
replace B and C, restart the machine, and check the direction of motor rotation.
3) Common problem: If the motor is noisy or the motor fan cannot rotate evenly after the motor
starts, please use an electric meter to check whether the power input is stable and the voltage
meets the requirements.
8. TESTING
In manual mode, activate the mold close button, and the machine mold will slowly close.
If the machine does not shake, it proves that the machine is ok, and you can directly use the machi-
ne to work normally.
If the machine shakes, it proves that there is a small amount of air remaining inside the machine.
Solution:
Remove the front limit and the rear limit, please pay attention to put them on a clean cardboard box
or cotton cloth, do not touch magnets and iron objects.
Then press the mold to open and close, each time you have to wait for the pressure gauge to
display the pressure, and then switch to another button.
Repeat five rounds.
Remove the air inside the machine, and finally put the micrometer and the rear limit back to the
original position.
Please take care to protect the sensor link cable.
Don't knock, otherwise it will affect the use of the machine.
9. FREQUENTLY QUESTIONS AND SOLUTIONS
Please check the oil level gauge or the turning direction of the motor fan, according to the previous
introductions, and eliminate the problems step by step according to the following solutions.
Questions 1: Mould base in the nose can not move forward
