background image

NOTE :  This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to Part 15
of the FCC Rules.  These limits in a residential installation.
This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance   with the
instructions, may cuase harmful interference to radio
communications.  However, there is no guarantee that
interference will not occur in a particular installation.  If this
equipment does cause harmful  interference to radio or
television reception, which can be determined by  turning the
equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures :  
- Reorient or relocate the receiving antenna.  
- Increase the separation between the equipment and receiver. 
- Connect the equipment to an outlet on a  circuit different from

that to which the receiver is connected. 

- Consult the dealer or an experienced radio, TV technician for

help. 

This digital apparatus does not exceed the Class A/Class B
(whichever is applicable) limits for radio noise emissions from
digital apparatus set out in the Radio Interference Regulations
of the Canadian Department of  Communications.  

Avis de conformité aux normes du Ministère des
Communications du  Canada.

Le present appareil numérique n

emet pas de bruits

radioélectriques depassant les limites applicables aux appareils
numériques de Class A/de Class B (selon le cas) prescrites dans
le règlement sur le brouillage radioélectrique édicte par le
ministère des communications du canada.  

IMPORTANT SAFEGUARDS

FEDERAL COMMUNICATIONS COMMISSION RADIO
FREQUENCY INTERFERENCE STATEMENT

CANADIAN DEPARTMENT OF COMMUNICATIONS
COMPLIANCE STATEMENT

1. Read all of these instructions.

2. Save these instructions for later use.

3. Unplug this monitor from the
wall outlet before cleaning.  Do not
use liquid cleaners or aerosol
cleaners. Use a damp cloth for
cleaning.

4. Do not use attachments not recommended by
the monitor manufacturer as they may cause
hazards. 

5. Do not use this monitor near water for
example, near a bathtub, washbowl, kitchen sink,
or laundry tub, in a wet basement or near a
swimming pool, etc. 

6. Do not place this monitor on an
unstable cart, stand, or table.  The
monitor may fall, causing serious
injury to a child or adult, and
serious damage to the appliance. 

7. Slots and openings in the
cabinet and the back or bottom are
provided for ventilation, and to
ensure reliable operation of the
monitor and to protect it from

overheating, these openings must not be blocked
or covered. The openings should never be
blocked by placing the monitor on a bed, sofa,
rug, or other similar surface. This should never
be placed  near or over a radiator or heat register.
This monitor  should not be placed in a built-in
installation such as a  bookcase unless proper
ventilation is provided.

8. This monitor should be operated
only from the type of power source
indicated on the marking label. If
you are not sure of the power
supplied to your home, consult

your monitor dealer or local power company.

9. This monitor is equipped with a
3-wire grounding type plug, a plug
having a third (grounding) pin. This
plug will only fit into a
groundingtype power outlet. This is

a safety feature.  If you are unable to insert the
plug into the outlet, contact your electrician to
replace your obsolete outlet.  Do not defeat the
purpose of the groundingtype plug. 

10. Do not allow anything to rest
on the power cord.  Do not locate
this monitor where the cord will be
abused by persons walking on it. 

11. Follow all warnings and instructions marked
on the monitor.  

12. For added protection for this

monitor during a lightning storm,
or  when it is left unattended and
unused for long periods of time,
unplug it from the wall outlet. This

will prevent damage to the set due to lightning
and powerline surges. 

13. Do not overload wall outlets and extension
cords as this can result in fire or electric shock. 

14. Never push objects of any kind into this
monitor through cabinet slots, as they may touch
dangerous voltage points or short out parts that
could result in a fire or electric shock. Never spill
liquid of any kind on the monitor. 

15. Do not attempt to service this
monitor yourself as opening or
removing covers may expose you
to dangerous voltage or other
hazards.  Refer all servicing to

qualified service personnel. 

16. Unplug this monitor from the wall outlet and
refer servicing to qualified service personnel
under  the following conditions: 

a. When the power cord or plug is damaged or
frayed. 

b. If liquid has been spilled into the monitor. 

c. If the monitor has been exposed to rain or
water. 

d. If the monitor does not operate normally by
following the operating instructions.  Adjust only
those controls that are covered by the operating
instructions as improper adjustment of other
controls may result in damage and will often
require extensive work by a qualified technician
to restore normal operation. 

e. If the monitor has been dropped or the cabinet
has been damaged. 

f. When the monitor exhibits a distinct change in
performance this indicates a need for service. 

17. When replacement parts are
required be sure the service
technician has used replacement
parts specified by the manufacturer
that have the same characteristics

as the original part.  Unauthorized substitutions
may result in fire, electric shock, or other
hazards. 

18. Upon completion of any service or repairs to
this monitor, ask the service technician to
perform routine safety checks to determine that
the monitor is in safe operating condition. 

CAUTION:

Any changes or
modifications not
expressly
approved by the
party responsible
for compliance
could void the
user

s authority to

operate the
equipment. 

Содержание 902D















Отзывы: