20. Point steam away from power point switch and furniture.
21. Keep flammable materials away from appliance.
22. Handle power cord carefully as cord may malfunction if dropped.
23. It is normal for smoke and smell to be emitted during first use, it will
stop after a short period of usage.
24. Be extra careful when moving the appliance filled with hot water.
25. Do not fill
above the “Full” water guide mark.
26. Do not cover or block steam vent with cloth or any material.
27. Always ensure the lid is closed properly.
28. Make full use of handle when moving the appliance.
How To Use
HAZARDS
Removing and attaching top lid
1. Pull on lid lock and open lid to about 45-degrees angle and
remove lid from securing hinge.
2. To attach, insert the shaft of the lid into the hinge holder. Close
and press on lid unit it clicks.
Never remove lid while the appliance is operating.
Be cautious of steam when opening lid.
-4-
Using the dispenser for the first time
Wash and rinse inner tank with water.
Fill water up to full line.
Boil once and discard water by pumping it out.
1. Open top lid and add water
Pull up on the lid lock and open top lid.
Fill with cold water from another container, such as a kettle or
pitcher. Do not fill directly under faucet.
To prevent overflow, do not fill above the maximum mark.
Be careful not to splash water onto the control panel.
2. Close the top lid
Carefully close lid by pressing down until a click is heard
Do not close lid forcefully, hot water may gush out and scald.
3. Boiling the water
Unit begins to function (boil) once power is connected.
First attach body plug to receptacle then plug into to wall
outlet.
Never connect power when unit is empty.
When rotating the body, be cautious of the power cord.
4. Reading the control panel
“Boil” light is on during the boiling cycle
Will switch to “Keep Warm” automatically when water is
boiled
Do not open the top lid.
Do not touch the steam vent.
Do not place cloth or other items covering the steam vent.
Do not dispense water while water is boiling.
5. Dispensing water
– electric pump
Press the “Dispense” button to dispense hot water
Hot water may not dispense smoothly immediately after
boiling, this is due to air bubbles trapped inside.
Never press the “Dispense” button if dispenser is empty.
Electric dispense will not work if unit is unplugged.
6. Dispensing water
– manual pump;
Switch manual pump lock to “Unlock”
Press down on the manual pump
NOTE:
Add water before water level reaches the “Refill” line.
7. Reboil function
Make sure water level is above the “Refill” mark before
reboiling.
Re-boiling a full container takes about 3 minutes.
The re-boil key may not respond right after the water has
boiled.
-5-
To protect against electric
shock, do not immerse base,
cord or plug in water or other
liquid.
Do not place on
unstable surfaces.
Only fill with pure water.
Do not put milk, tea, ice or
any other substance into
dispenser.
Do not fill above the maximum level
mark inside the tank or lower than
the minimum level to avoid damage
to the product.
Do not place on or near a hot gas or
electric burner, or a heated oven.