DAELIM S1 - CATALOG, Руководство пользователя

Страница: 48 / 67

Erect main stand and place vehicle in
upright position on level ground.
Check the spring for damage or loss of
tension and the side stand assembly for
freedom of movement.
Check the side stand ignition cut-off
system;
Put the side stand up.
Start the engine.
Lower the side stand. The engine
should stop as you put the side stand
down.
If the side stand system does not
operate as described, inspect it in the
closest authorized repair center.
A rubber boots is assembled on the cable
to protect the inner cable.
Make sure that this part is placed firmly
around the correct part of the cable. When
washing the vehicle, do not directly spray
water on to the rubber boots or scrub it
with brush. Use a dry cloth to clean this
area.
Check the installing condition of rubber
boots daily. After adjusting the free play
of throttle grip, never forget to place the
rubber boots to the original position.
45
CABLE RUBBER PART SIDE STAND INSPECTION
WARNING
Infiltration of the foreign materials or
water caused by damage of rubber
boots (disengagement, tearing, etc.)
may cause freezing in winter season
resulting in faulty operation. It may
lead death or serious injury by
decreasing of sudden acceleration and
braking force due to engine rpm.
If any damage is found, replace with the
new on immediately.