DAELIM DAYSTAR -, Руководство пользователя

Страница: 48 / 62

●
Erect main stand and place vehicle in
upright position on level ground.
●
Check side stand spring for signs of
damage and lubrication state on joints.
A rubber part is assembled on the cable to
protect the inner cable.
Make sure that this part is placed firmly
around the correct part of the cable. When
washing the car, do not directly spray
water on to the rubber part is dirty, use a
dry cloth to clean this area.
●
Make sure to stop the engine prior to car
washing.
● Be careful not to allow water to enter
the muffler during the washing.
Water inside the muffler may cause an
improper engine starting or rust occurr-
ence.
● Do not let water get inside the braking
system during the washing, as water
inside the brake system may weaken the
braking power. Upon completion of
washing, select a safe place where there
is no traffic obstruction, and start the
vehicle. Lightly apply the brake while
driving at a slow speed and check the
braking power. If the braking power has
been weakened, apply brake lightly
while driving at a slow speed to dry up
the brake system.
●
Take precautions when waxing the
vehicle.
Excessive polish of the painted section
and/or the resin part with compound
wax might damage the painted section
causing discoloration of the affected
area.
46
SIDE STAND CABLE RUBBER PART NOTABLES FOR CAR WASHING
INSPECTION PART INSPECTION PART RUBBER
CONNECTOR
SIDE STAND
SPRING
CAUTION
●
Infiltration of the foreign materials
or water caused by damage of
lever(disengagement, tearing, etc.)
may cause freezing in winter
season resulting in faulty operation,
sudden accelation and braking
force decrease. If any damage is
found, replace with the new on
immediately.
**vl125(~47P) 02.11.5 4:34 PM 페이지46