All specifications subject to change without notice.
Phone: (800) 793-0093
www.dacor.com
PLANNING
GUIDE
4.40
RNTT365GB
Renaissance 36” Wide
Drop-in,Touch-Control Gas Cooktop
Document # PG04-010
Revised 09/02/15 Page 3/5
Cabinet and Countertop Layout
WARNING
• To reduce the risk of personal injury caused by reaching
over a hot appliance, avoid locating cabinet storage
space directly above the cooktop.
• Failure to meet or exceed the maximum and minimum
dimensions/clearances stated in these instructions may
result in a fire hazard.
• Follow the countertop manufacturer’s instructions
regarding the minimum corner radius, use of heat
reflective tape, reinforcement of corners, etc.
◊
Carefully check the location where the cooktop will be
installed. For best performance, the cooktop should be placed
away from drafts that may be caused by doors, windows, and
heating and air conditioning outlets.
◊
This appliance must be installed in a well ventilated room. To
reduce the risk of personal injury and to reduce accumulated
smoke in the room, Dacor strongly recommends installing
a range hood. A range hood should project horizontally a
minimum of five (5) inches beyond the face of the cabinets.
To allow clearance for hold-down brackets:
◊
The gas supply piping, gas shut-off valve, and the electrical
outlet must be positioned so they do not interfere with the
cooktop when it is installed.
◊
If installing another appliance in the cabinet below, allow for
the routing of gas and electrical service behind it.
The installation must have these access and clearance
allowances:
◊
Access to the gas shut-off valve and regulator after the unit is
installed.
◊
Access to the electrical outlet when the cooktop is in place.
The 72-inch (183 cm) power cord must be able to directly
reach the electrical outlet.
◊
Clearance inside the cabinet to allow for proper hold- down
bracket installation.
All tole1/16” -0” (unless otherwise noted).
Minimum Overhead Clearances
13" max.
3
(33.0 cm)
3
Not applicable for cabinets more than a horizontal distance of
1 1/8” (2.9 cm) from edge of cooktop. Allow 2 7/8” (7.3 cm)
from cutout edge.
15" min.
1, 3
(38 cm)
Combustible
surface to rear
Combustible overhead
cabinets
25" min.
1, 2
(63.5 cm)
36" min.
4
(91.4 cm)
See cutout
dimensions
2
If installing with an overhead vent hood, also check the hood
specifications for minimum required clearances.
1
Measured from the cooking surface (top of cooktop grate).
4
42” (106.7 cm) recommeded.