Dacor Millennia MORD230S, Инструкция по использованию и уходу

Страница: 23 / 28

21
Problem May Be Caused By What to Do
Oven will not heat. Oven settings are not correct. Follow mode selection and clock settings
as specified in Setting up Your Range .
Oven is set for delay timed
cooking.
Oven will turn on automatically at time
set. If desired, press CANCEL • SECURE
key to cancel out of delay timed cooking.
Clock displays incorrect
time of day.
Time of day is not set. Press CLOCK key, then press TIME •
TEMP key to set correct time of day.
Power supply has been inter-
rupted.
Reset time of day.
Foods over-cook. Incorrect cooking time, tem-
perature.
Adjust time, temperature or rack position.
Oven temperature calibra-
tion differs from your previous
oven.
Adjust oven temperature. See Care and
Cleaning section.
Foods under-cook. Incorrect cooking time, tem-
perature.
Adjust time, temperature or rack position.
Oven temperature calibra-
tion differs from your previous
oven.
Adjust oven temperature. See Care and
Cleaning section.
Oven does not self-clean. Door is not shut tight, so auto-
matic door latch will not lock.
Close door tightly.
Oven settings are not correct. See Care and Cleaning section.
Oven is set for delay timed
cleaning.
Oven will turn on automatically at set
time. Press CANCEL • SECURE key to
cancel out of delay timed cleaning.
Oven light will not work. Light bulb is burned out. See Care and Cleaning section.
Door will not open. Oven is in self-clean mode. If oven is hot, door latch will release
automatically when oven temperature
falls below 390˚F at end of cycle.
If self-clean was just selected and the
oven is still cool, press CANCEL •
SECURE to turn off self-clean. The door
will open in about 30 seconds.
Oven will not heat after
self-clean.
Time of day is not set due to
power failure.
Press CLOCK key, then press TIME •
TEMP key to set correct time of day.
Oven settings are not correct. See Operating Your Range section.
Oven is set for Delayed Time
mode.
Oven will turn on at present time. If
desired, press CANCEL • SECURE button
to cancel out of delay timed mode.
Error Code Cause
F0 Touch key is stuck in a depressed position.
F1 Relay circuit failure.
F2 Oven temperature exceeded the clean/cooking runaway temperature.
F3 Short circuit in the oven temperature sensor.
F4 Open circuit in the oven temperature sensor.
F6 Failure in the EEPROM check comparison. (Only time of day and timer will operate.)
F7 Failure of the self-clean automatic door latch circuit.
F8 Failure of the door latch motor.
Before You Call for Service