Dacor EF36LNBSS, Руководство по установке

Страница: 20 / 48

18
Custom Panel Installation - IF36
Series Models (Continued)
Top Grille Panel
Grasp both ends of the top grille. 1.
Push straight up, then pull straight out. Place the top grille 2.
panel-side down on a soft working surface.
Remove one end cap by loosening the nuts and sliding the 3.
end cap off.
Slide the custom panel into the top grille channel and reattach 4.
the end cap.
Replace the top grille in the cabinet side trims and pull the 5.
panel down slightly to lock it into place.
Adjust Doors
Door Swing Adjustment
Check that the refrigerator door can open freely. If the door 1.
opens too wide, remove the door stop screw or screws
(depending on your model) from the bottom hinge with a Torx
T15 screwdriver.
Hold the door open to a position that is less than 90°.
2.
Replace the door stop screw or screws in the bottom hinge 3.
and tighten.
IMPORTANT : Do not place the door stop screw in the 130°
position on IF Series models. See “Handle and Door Clearances.”
Door-to-Door or Door-to-Refrigerator Trim
Adjustment
Loosen, but do not remove, the four Torx 27 flat-head 1.
mounting screws and the two ¼” hex head mounting screws.
Adjust the top hinge of either door to align it with the other
2.
door or the refrigerator trim.
Tighten the four Torx 27 flat-head mounting screws to a torque
3.
of approximately 100 inch-pounds (11.3 Nm) and tighten the
two ¼” hex head mounting screws.
Installation Instructions
B. 130° position
A. Door stop screw
C. 110° position (IF series refrigerators)
D. 90° position
B
A
C D
A. Top grille
B. Cabinet side trim
B B A
C. Bottom rail
D. Nuts
E. End cap
F. Top rail
F
D
C
E
G. Custom panel
G
A. Torx 27 flat-head mounting screws
B.
¹⁄
4
" hex-head mounting screws
A
B