8
i
nsTallaTion
i
nsTruCTions
C
omPleTe
i
nsTallaTion
Turn the water supply line valve to the open position.
1.
Wait a few minutes. Check the water line connections for
2.
leaks.
Remove all boxes, parts packages and packing materials
3.
from the interior of the refrigerator.
See the
4.
Care and Cleaning
section in the use and care
manual for instructions. Remove the film and cardboard from
the grille and doors or door frame, depending on your model.
Install the shelves and bins in the refrigerator and freezer
5.
compartments.
The controls are preset at the factory to the midpoint setting.
6.
Check that the compressor is operating properly and that all
the lights are working.
Flush the water system before use. See
7.
Water System
Preparation
.
To get the most efficient use from your new refrigerator, read your
use and care manual. Keep these installation instructions and the
use and care manual near the refrigerator for easy reference.
W
aTer
s
ysTem
P
reParaTion
Please read before using the water system.
Immediately after installation, follow the steps below to make sure
that the water system is properly cleaned.
Do not use with water that is microbiologically unsafe or of
unknown quality without adequate disinfection before or after
the system. Systems certified for cyst reduction may be used on
disinfected waters that may contain filterable cysts.
Hold a sturdy container under
1.
the water spout and press the
dispenser button. Flush the
water system by dispensing
and discarding 6 qt. (5.7 L) of
water. Cleaning the system
will take approximately 3 to
4 minutes and will help clear
air from the line. Additional
flushing may be required
in some households. As air
is cleared from the system,
water may spurt out of the
dispenser.
Make sure the ice bin is in
2.
place and the ice maker arm
is down.
After the freezer section
3.
reaches between 0° to 2°F
(-18° to -17° C), the ice
maker fills with water and
begins operating. You will
have a complete harvest of
ice approximately every three
hours.
Allow approximately 24 hours
4.
after installation to receive the first harvest of ice.
Discard ice created within the first 12 hours of operation to
5.
assure the system is flushed of impurities.
