10
Attach the Anti-tip Brackets:
CAUtION
Make sure to anchor at least one anti-tip bracket on
•
each side of the dishwasher.
The anchoring material must be no more than 1/4”
•
(6mm) from the anti-tip bracket.
To prevent leaks, square the dishwasher in the cut-
•
out. When attaching the anti-tip brackets make sure
the tub and frame are not skewed so that the tub
gasket contacts the door liner fully all the way around
the door.
Do not over torque the leveling legs. Doing so
•
will distort the dishwasher chassis leading to door
alignment problems and possible water damage.
To prevent damaging the dishwasher, adjust the
•
leveling legs only 1/2” (13 mm) at a time, per leg.
The anti-tip brackets protect against possible tipping
caused by heavy bottom rack loads on the door.
There are anti-tip mounting locations provided around
1.
the top and sides of the dishwasher front frame.
To attach the anti-tip bracket anchors, insert the
2.
anchoring screws through the 1/2” diameter access
holes inside the dishwashing compartment on the
ceiling and the sides, near the front. Make sure that the
anchoring screws pass through the anti-tip brackets
located on the outside of the dishwasher.
Square up the installation:
Check to make sure the dishwasher is square in the
•
cutout by observing the door to tub alignment on each
side. Readjust the top or bottom of the unit as needed to
square up the unit.
Installing the Unit in the Cabinet
(continued)
NOtE
: The leg nuts can be removed to make the
dishwasher lower. To do so:
Turn the leg until it comes out of the chassis.
1.
Remove the nut from the leg.
2.
Re-thread the leg into the chassis.
3.
Reach inside the chassis from the back and thread the
4.
nut onto the top of the leg.
Slide the Dishwasher into the Cutout
Pull the electrical wiring and both hoses (drain and
•
water supply) through the utility access hole(s) in the
side(s) of the cabinet as you slide the dishwasher into
the opening. Stop when the dishwasher contacts the
back wall or aligns with the front cabinet opening.
Installation Instructions
Side anti-tip
bracket
Top anti-tip
bracket
