Dacor DRT304, Инструкция по использованию и уходу, Страница: 7 / 16

5
Grate and Knob Installation
1. Gently set the grates
on top of the spill
tray. Put the legs
of each grate into
the corresponding
dimples. On model
DRT366S, the middle
grate is smaller than
the other two.
2. Attach the Sim-
merSear burner
knobs A as shown
below. The Sim-
merSear knobs have
a wider space between the large flame icon
and the simmer icon than the standard burner
knobs. Align the “D-shaped” opening on the back
of each knob with the end of the valve shaft.
Carefully push each knob on until it stops.
3. Attach the remaining knobs which operate the
standard burners B .
SimmerSear Knobs
Standard Knobs
Setting Up Your Cooktop
Burner and Grate Assembly
WARNING
Assemble the burners and grates only when the cooktop
is cool.
Remove the burner rings, burner caps and grates
from their shipping packages.
SimmerSear Burner Assembly
1. Install the SimmerSear burner ring(s) on top
of the SimmerSear burner base(s). Line up the
indentations on the bottom of the burner ring
with the pins on the top of the burner base.
2. Set the outer SimmerSear burner cap(s) on top
of the burner ring(s). Make sure the burner ring
is centered on top.
3. Set the inner SimmerSear burner cap(s) on the
center of the dual burner base(s). Line up the
ridge on the bottom of the cap with the pins on
the center of the burner base.
Standard Burner Assembly
1. Install the standard burner rings on the stan-
dard burner bases. Put the hole on the edge of
each ring over the igniter. Center the tabs on the
bottom of each ring in the hole in the center of
each base.
2. Install all the standard burner caps. The ridge on
the bottom of each cap must surround the top of
each ring.
SimmerSear
Burner Assembly
Ridge on bottom of
inner burner cap
Pin on burner base
Outer burner
cap
Burner
ring
Standard Burner
Assembly
Ridge on bottom
of burner cap
Igniter on
burner base
Burner
ring
Igniter
hole
B
A
A
B
B
B
B
B
A
A
B
B
DRT304S Knob
Placement
DRT366S Knob
Placement