13
Rear Trim Piece Installation
(Model DR30GIS/DR30GIFS only)
For self-rimming installations, with or without a raised vent,
install the included 1 inch deep rear trim piece to overhang
the countertop/raised vent in back. Use the two (2)
included #8 x 1/4 screws.
IMPORTANT:
If you are installing
a raised vent and the trim piece included with the range
is not 1 inch deep, you have a revision A range and must
order the appropriate trim kit (see notes on page 8).
Installing a Raised Vent (Optional)
Install the ERV3015 raised vent before final installation of
the range. See the installation instructions included with
the raised vent. If you are installing the raised vent with a
range with a serial number that starts with “FA” in a cabinet
that is 24 to 24 1/4 inches deep, you must install the
optional
3 1/2 inch side panels and 1 inch deep trim piece included
in kit (PN ADTK30GSR24).
IMPORTANT:
The raised vent attaches to the back portion
of the raised vent/range cutout. It is self-supporting in the
cutout and does not actually attach to the range itself.
Adjust the Range Height
1. For stand alone configurations, raise the range until
the top of the trim around the cooktop is at least
the same height as the countertop. For self-rimming
configurations, raise the range until the bottom of
the trim surrounding the cooktop is even with the
countertop. To adjust the height, turn the foot on the
bottom of each leg as shown below.
2. Use a level to make sure that the range does not tilt
front to back or side to side. Re-adjust the legs as
necessary.
up
down
Gas Connection
WARNING
•
Make sure the gas is turned off at the gas supply
valve before connecting the gas line.
•
Verify that the gas supply meets specifications before
connection. See page 5.
•
Do not apply excessive pressure when tightening gas
connections and fittings.
•
Do not use Teflon tape or plumber’s putty on flexible
gas line connections.
•
Test the gas lines for leaks as instructed before use.
If a leak is detected, open all doors and windows and
allow the gas to dissipate before fixing the leak and
testing the unit.
•
Do not use a flame to check for leaks.
•
The maximum gas supply pressure to the regulator
must never exceed 1/2 pounds per square inch (psi)
or 3.5 kPa.
•
The range and its individual shutoff valve must be
disconnected from the gas supply piping system
during any pressure testing of that system at test
pressures in excess of 1/2 psi (3.5 kPa).
•
The range must be isolated from the gas supply piping
system by closing its individual manual shutoff valve
during any pressure testing of the gas supply piping
system at test pressures equal to or less than 1/2 psi
(3.5 kPa).
•
For LP gas installations, the LP gas tank must have its
own high-pressure regulator in addition to the pressure
regulator installed on the range.
IMPORTANT:
The installed gas pressure regulator is pre-
set at the factory for the type of gas to be used with the
range. Verify that the range is compatible with the type of
gas available by checking the product data label affixed to
the range. Ranges intended for use with LP gases have
“LP” as a part of the model number. Consult your dealer if
the range is not compatible with your gas supply.
1. Make sure the gas supply valve is in the off position
and the range power cord is disconnected.
2. Connect a flexible gas supply line to the gas shut-off
valve previously installed on the stub out. The gas
line needs to be long enough to allow the range to be
pulled out for service.
3. Connect the gas line to the regulator on the back of the
range (see page 5 for location).
4. Turn all cooktop control valves to the
“OFF”
position.
5. Turn on the gas supply valve and check
all lines and connections for leaks using a
soap and water solution or an electronic
gas leak detector.
6. Turn the gas supply off.
“OFF”
symbol on
knob
Installation Instructions
Содержание Distinctive DR30GS/LP
