8
8. Find the gas regulator assembly shipped with the
unit.
9. Make sure the regulator adjustment knob is turned
all the way in the
OFF
direction.
10. Plug the end of the gas tubing leading to the wine
dispensing system into the gas regulator assembly.
11. Remove the plastic cap from the top of the argon
gas cylinder (must be ordered separately, see page
6).
12. Insert the top of the gas cylinder into the bottom of
the gas regulator assembly and turn it clockwise
until it is snug. Do not overtighten.
13. Turn the regulator knob in the
On
direction until it
stops.
14. Open the door on the front of the unit. Swing the
spout cover to the up position.
15. Make sure the power switch, located on the left
side of the bottle bay, is slid all the way down, to
the
OFF
position.
16. Plug the power cord into the electrical outlet.
17. Slide the main power switch all the way up to the
On
position.
18. The unit will run through a series of self-tests,
which will take several seconds. Once this process
is completed, the blue lights on the control panel
will come on, indicating that the wine dispensing
system is ready for use.
IMPOrTAnT:
When the
system is powered up for the first time,
LOCKeD
will appear on the display. See
Unlocking the
Control Panel
in the operation section of the use
and care manual for unlocking instructions.
19. Push up on the spout cover release lever on the
bottom of the spout cover. Hold the lever up as you
lower the cover down into place.
CAuTIOn:
Do not
push down on the spout cover without pushing up
on the lever. Damage to the lever will result.
20. Once the spout cover is closed, close the bottle
bay door. Push in slightly just above the lock until it
snaps shut.
Installation Instructions
Regulator
adjustment
knob
Gas supply
line from wine
dispensing
system
Regulator
assembly
Argon
gas
cylinder
Spout cover
release lever
(on bottom of
spout cover)
Switch Positions
ON
RESERVED
NOT USED
OFF
Main Power Switch
(under spout cover)
For use by
authorized
service
personnel only
