Dacor Discovery DYRP36D-C-S, Инструкция по использованию и уходу

Страница: 55 / 60

53
Problem May Be Caused By What to Do
Oven will not heat. Oven setting not correct. Touch CANCEL · SECURE , then follow instruc-
tions in Operating The Oven section.
Oven set for Delay Start. Oven will turn on automatically at the preset
time. Touch CANCEL · SECURE to return to
normal operation.
Attempting to broil with the meat
probe connected.
Broil modes will not work when meat probe is
connected. Disconnect meat probe.
Door open during preheat or when
using one of the broil modes.
Oven will not heat with door open during pre-
heat and Broil. Close door.
Oven does not Self Clean/Gre-
enClean.
Oven door not shut tightly. Check for obstructions. Shut door tightly.
Oven not set properly. Follow instructions in Care and Cleaning sec-
tion.
Meat probe connected. Oven will not start Self Clean cycle when meat
probe is connected. Disconnect and remove
meat probe.
Oven temperature over 400°F
(204°C).
Control panel does not allow Self Clean to
start when oven is over 400°F (204°C). Wait
for oven to cool, then start Self Clean.
Oven door will not open. Oven is set to Self Clean. Check display. If Locked symbol appears on
display, oven door cannot be opened. Wait for
oven to complete Self Clean or touch CANCEL
· SECURE . Door will unlock once oven has
cooled.
Oven lights will not work. Oven in Self Clean mode. Lights do not work when oven is in Self Clean
mode. See page 46.
Oven in Sabbath mode. Lights do not work when oven is in Sabbath
mode. See page 39.
Light bulbs burned out. Replace light bulbs.
Oven lights will not turn off. Light key is set to on. Touch light key to turn lights off.
Door ajar. Make sure the door is completely shut.
Sabbath mode does not work. Meat probe connected. Oven will not start Sabbath mode when meat
probe is connected. Disconnect and remove
meat probe.
Oven goes into Keep Warm
mode too quickly after meat
probe is connected.
Meat probe connector is still wet
after cleaning.
Dry the metal portion of the plug that con-
nects to the oven using a soft dry rag.
Cooling fan continues to run
after oven has been turned off.
Normal operation. The cooling fan may run for a while after the
oven is turned off, until the internal parts have
cooled.
Time on display not correct. Clock not set to automatic or WiFi
internet service not available.
See Clock/Date Settings on page 10.
Control panel does not “beep”
when touching the keys on the
control panel and when the
timer runs down to zero.
Control panel tones disabled. Enable control panel tones. See Oven Tone
Settings on page 11.
Timers do not work. Oven set to Sabbath mode Normal operation. Timers are not operational
when oven is in Sabbath mode.
continued...
Before You Call for Service