All specifications subject to change without notice.
Phone: (800) 793-0093
www.dacor.com
PLANNING
GUIDE
inset installation Dimensions
■
Measure the distance from point A
(as shown) to the back wall. Add
¹⁄
32
” (0.8 mm) to this measurement
to allow the side panel to fit into the
trim.
■
If the panel is more than ³⁄
8
” (9.5
mm) thick, rout the front edge to
allow the side panel to fit into the
trim.
recessed inset installation Dimensions
■
Measure the distance
from point B (as
shown) to back wall.
■
Route the front edge
of the support board
or attach a ³⁄
8
” (9.5
mm) board to hold the
panel in the cabinet
side trim.
DYF42BNDI, DYF48BNDI
Discovery 42” and 48” Wide
Built-In Custom Panel Refrigerators
Document # PG11-013
Revised 02/04/13 Page 5/5
Custom Handle Dimensions and installation
◊
Before installing a custom panel
assembly, you must install the
custom handle hardware. The
handle and handle mounting
hardware are not provided with the
refrigerator.
◊
Dacor recommends handles with
larger D-style pulls. Any handle
designed for use with an appliance
should produce satisfactory
results. Handle kits are available
through your Dacor dealer.
◊
Handle kits do not include the
necessary mounting screws
since screw length required
varies with the total thickness of
the panels. The panel craftsman
must determine and obtain the
proper mounting screws for
the application. If using screws
with thick heads, they must be
countersunk into the panel before
installing the handles.
iMPOrTANT:
Dacor does not advise
the use of single pull knobs.
Custom Side Panels
Custom side panels may be needed when not enough space is available
to have cabinets on both sides of the refrigerator or when the refrigerator is
placed at the end of a cabinet run.
refrigerator and Side Trim Dimensions
The width and height of a side panel are determined by the type of
installation you are planning.
NOTES
:
■
The dimensions shown are actual product dimensions and may not
reflect the needed installation dimensions.
■
The side panel should be a
minimum of ½” (1.3 cm) thick to
avoid warping.
■
If the opening depth is 25” (63.5
cm) or more, you may want to
install a support board on rear
wall.
11
⁄
16
"
(60.2 cm)
23
3
⁄
8
" (9.7 mm)
1
⁄
16
" (1.5 mm)
3
⁄
32
" (2.4 mm)
3
⁄
16
"
(4.8 mm)
Back wall
B
Back wall
A
A. Countersunk screw
Trim frame
surrounding door
B. Handle
C. Door panel assembly
Door
B
A
C
20" Typ.
(50.8 cm)
36" Max.
(91.4 cm)
REFRIGERAtoR
SIDE tRIm
