Dacor DHW301, Руководство по установке, Страница: 7 / 16

5
On the hood itself, measure the distance between 2.
the bottom of the hood and the top of the mounting
bracket hole on the hood being installed. Using a
pencil, draw a short line on the wall the same dis-
tance above the horizontal line drawn in step 1. You
will use this line to determine the height of the mount-
ing bracket when attached to the wall.
note: The mounting hardware
included with the hardware packet
is suitable for mounting to brick and
masonry only. If mounting the range
hood to drywall, Dacor strongly
recommends the using a sturdy
anchoring system designed for
use with drywall. In addition, Dacor
strongly recommends that you
install a reinforced mounting block
between the studs behind all hood
mounting locations.
Using a pencil, draw a level 1.
horizontal line on the wall
where the bottom of the hood will be. The line must
be at least 30 inches above the cooking surface.
Installation Instructions
Unpack the box and verify that all parts listed have been
provided. If any item is missing or damaged, please con-
tact the dealer immediately. Do not install a damaged or
incomplete appliance. Make sure you have everything
required for proper installation before proceeding.
Hood assembly with filter(s) ■
Chimney assembly (2 piece) ■
Chimney mounting bracket ■
Mounting bracket ■
Blower exhaust cowling (2 blower units only) ■
Mounting and assembly hardware ■
Use and care manual
A
A
B
C
C
B
D
D
E
F
F E
wArning
Observe all governing codes and ordinances during installation. Contact your local building department for fur- •
ther information.
A qualified technician must complete the installation of this built-in appliance. The owner is responsible to make
•
sure the hood is properly installed.
Do not install the range hood unless the power supply provided meets the required
• Electrical Specifications
(see page 3).
To avoid an electric shock hazard and property damage, locate electric wires and water pipes and avoid drilling
•
or cutting in the vicinity.
The range hood is heavy. To prevent personal injury and property damage install the hood only as specified in
•
the following instructions and use only the hood mounting bracket provided with the unit. Make sure all screws
used to mount and assemble the hood are tight. Failure to properly anchor the hood to the wall may result in
personal injury due to the unit falling. Hanging the range hood requires two people. Do not attempt to lift the
hood without assistance.
Top of mounting
bracket hole
Verify the Package Contents
Installing the Mounting Bracket