Dacor DDWF24S, Инструкция по использованию и уходу

Страница: 11 / 24

9
Carefully pour the rinse agent into the filler hole 2.
until the rinse agent level is even with the top of
the hole. Do not overfill.
Wipe up any spillage. 3.
Replace the rinse agent cap and turn it clockwise 4.
to the closed position.
Adjusting the Rinse Agent Dispenser
The rinse agent setting is located under the rinse
agent cap.
To change the setting:
Remove the rinse agent cap. 1.
If you have spotty or improperly dried dishes, 2.
move the arrow to the next higher number. If you
have streaks on your dishes, move the arrow to
the next lower number. The harder the water, the
more rinse agent required for acceptable results.
Replace the cap. 3.
Check the dishes after the next wash load. 4.
Continue adjusting the rinse agent dispenser up
or down according to the guidelines above until
you have spot free, streak free, dry dishes.
NOTE : If you have very soft water and still
experience streaking when the dispenser is set to
position 1, you can dilute the rinse agent with water
before pouring it into the dispenser to get acceptable
results.
Operating Your Dishwasher
Filling the Rinse Agent
Dispenser
important
Rinse agent is important to the drying process •
of the dishware. It also reduces spotting.
Dacor recommends that you keep the rinse
agent dispenser full at all times. However,
some customers with soft water may not
need rinse agent. If you have soft water, your
dishes may dry better without rinse agent.
If you use a dish washing detergent
•
containing a rinse agent additive, do not fill
the rinse agent dispenser to avoid a film on
the dishes.
The rinse agent indicator on the dispenser turns •
clear when it is empty.
The rinse agent dispenser must be properly •
adjusted. Too little rinse agent will allow spotting
and drying problems. Too much rinse agent will
cause foaming and streaking.
When the water hardness exceeds 3 gpg, you
•
should use rinse agent with citric acid (acid rinse
agent).
To refill the rinse agent dispenser:
Turn the rinse agent cap counter-clockwise to the 1.
open position and lift it out.
6
3
4
5
2
1
M A X
Filler hole
6
3
4
5
2
1
M A X
Move arrow to adjust
Closed Open
Not empty
Empty
Rinse agent indicator