Dacor CM24T-1, Руководство по установке

Страница: 8 / 16

• Cut a section of the supplied Ø 4mm (5/32”) Teflon
hose long enough to connect between the coffee
system water inlet quick-release fitting and the
regulator without binding or kinking.
• Insert one end of the Teflon hose (Ø 4mm) into the
quick-release fitting on the appliance. Then pull it out
slightly to make sure that it is secure.
• Connect the hose connected to the appliance to
the output of the regulator. Pay attention to the flow
direction arrows on the pressure regulator.
IMPORTANT: If you connect the hoses to the regulator
backwards, the water will not flow into the coffee
system and it will not work.
• Insert the end of the second hose into the input on the
regulator.
• Attach the third quick-release fitting to the second hose.
• With the main water valve is closed, attach the quick-
release fitting to the house plumbing. You can use the
included hose fitting to connect the quick connect to a
1/4” hose or water line (see below).
IMPORTANT: Connection to a house water supply with
a diameter larger than 1/4” requires an adapter (not
supplied). The adapter needs to have a 1/4-19 BSPP
female thread to connect to the quick release.
Pressure Regulator:
IMPORTANT:
The water pressure at the output of the
pressure regulator may not exceed 3.0 bars/43.5 psi
(1.5 bars/21.8 psi minimum). To adjust the output, pull
the pressure regulator control knob out slightly. Turn it
clockwise to increase the output pressure. Turn it counter-
clockwise to reduce the pressure. After adjustment, gently
push the control button back in.
I
nsTallaTIon
I
nsTruCTIons
Pressure
Regulator
Output
Pressure
Adjustment
Control
Knob
Pressure Gauge
Quick-Release
Fitting
Flow Direction
Arrow
Quick-Release
Fitting
Gauge O-ring
(black)
Pressure Regulator Assembly
• Install the pressure regulator bracket on the back of
the left or right guide at the back of the appliance as
shown.
• Mount the pressure regulator on the bracket.
p
lumbIng
I
nsTallaTIon
(m
oDel
Cm24p o
nly
)
CAUTION
To prevent damage to the coffee system due to hard water, prior
to installation check the water hardness for building where you
will be installing the coffee system (see page 3). If necessary
have a qualified water treatment specialist install a water
treatment system. The water treatment system must be installed
between the house plumbing and the coffee system regulator;
• Remove all of the parts from the regulator kit
packaging. The kit includes 4mm (5/32”) Teflon hoses,
a pressure regulator, three quick-release fittings, a
pressure gauge, and a mounting bracket.
• Assemble the pressure regulator gauge and two of the
quick-release fittings as shown below.
Hose Fitting
Quick Release
Connector from
regulator
House Fitting
Regulator
Control Knob
Water Inlet Quick-
Release Fitting
Connect to house
water source