PHW Series Hood Recirculation Kit
Page 3
STEP 7
Using sheet metal screws and duct
tape, attach the end of the duct length
cut in step 6 to the exhaust outlet on
the top of the blower assembly. Use a
level to make sure the duct is vertical.
Drill pilot holes as necessary for the
sheet metal screws.
STEP 8
Attach the top cap to the top of the
duct installed in step 7.
STEP 9
Install the hood chimney according to
the
Installing the Chimney
section of
the hood installation instructions.
Top cap
Chimney
mounting
bracket
Duct
Blower
assembly
STEP 10
Remove the mesh type filters from the hood. To remove, pull down on the release
lever and pull inward, then lower out of the hood.
Under side
of hood
Mesh
filter
Release
lever
Filters located in
under side
continued...
