dacell DN-AM210, Руководство пользователя

Страница: 9 / 14

8
4. How to operate
4-1. Power connection
○
1
Please only use the exclusive AC code (5-tube) for the power cord. When AC
is not grounded, please make the connection by using the ground connector
which is located on the backside of lamp.
○
2
Please check the AC power selecting switch and then supply power to the
device. If the lamp is not lighted, please check the fuse and power selecting
switch.
4-2. Sensor connection
4 Gauge Transducer
Full Bridge Connection
4-3. High Level Voltage Input
This device can measure the signal that inputted in DC (DCDT, High level,
Thermocouple etc).
For the measurement, following conditions should be satisfied.
○
1
On Common mode, the amp input should be as

10V. Please be careful since
when over

10V is inputted, the signal source will be cut off.