- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - ▲
I
NSTRUCTION
M
ANUAL
MEGA-T300b
Abrasive Cutter
3601 E. 34th St. Tucson, AZ 85713 USA Tel. +1 520-882-6598 Fax +1 520-882-6599 email: [email protected] Web: http://www.metallographic.com
Please read this instruction manual carefully and follow all installation, operating and safety guidelines.
2.3 Installation
!
Install unit carefully! Improper installation voids warranty.
!
The
MEGA-T300
should be placed on a flat
stable surface.
TO OPEN HOOD, CUTTER IS SHIPPED WITH THE
LOCKOUT SWITCH TURNED TO UNLOCK. AFTER
CONNECTING POWER, TURN SWITCH TO
LOCK TO OPEN HOOD AND TO USE CUTTER
Connect coolant tank
supply, drain and
electrical connections.
!
Electrical connections—The standard saw is designed to operate at 208-220V 3-phase
(120V-120V-120V-ground) (optional 380/400/480V)
Verify voltage on nameplate
!
Verify the direction of rotation of the cut-off wheel. The wheel should turn from top to bottom
as viewed from the front of the machine.
CAUTION
Before installation or when there
is no power to the machine, the
hood cannot be opened with the
interlocking safety device in the
LOCK
position. To open the
hood without power hook-up,
turn the interlocking device with
key to the
UNLOCK
position
(used for service and shipping).
Main Power switch
(Installation continued on next page)
7
Turn to Lock
position to operate
Shipped in the
Unlock
