
Setup
1.
Using the telephone line cord supplied, plug one end into the unit’s
Data
jack (located on the bottom), and the other end into the system or
phone jack.
2.
Connect the power adapter to the A/C jack on the unit’s left side.
3.
Plug the handset cable into the unit’s
Handset
jack (located on the
bottom), and the other end into the handset.
Auto-Log
One-touch dialer #10 (bottom right) is used for the Auto-Log feature. If
the
Auto-Log
switch is on, whatever is programmed to this dialer will
automatically be dialed. This could be a phone number or perhaps user
ID.
The
Auto-Log
switch is located on the back of the unit.
DIP Switches
There are four DIP switches located on the bottom of the unit. Switches
1 & 2 determine which emulation the unit uses.
DIP Switch 1:
On=Dictaphone emulation (DIP switch 2 must be off).
DIP Switch 2:
On=Lanier emulation (DIP switch 1 must be off).
DIP Switch 3:
Not used.
DIP Switch 4:
On=Programming enabled. Off=Programming disabled.
Programming Dialers
Before proceeding, verify that you have followed
Setup steps 1-3
, that
DIP switch 4 is on
, and that the
Auto-Log switch is off
.
1.
Pick up the handset and then connect to your system (this may
require entering a user ID and even dialing a telephone number).
2.
Press
Store
.
3.
Dial the number(s) you wish to have stored.
4.
Press the one-touch dialer you desire to program.
Repeat steps 2-4 for additional dialers.
Emulation
There are 2 different emulations for this model. The emulation
determines what digits are sent with the handset functions. You may
change the emulation at any time with the DIP switches.
Name
Record
Incremental REW/Play
Stop
Dictaphone
2
3
1
Lanier
2
3
4