2
Corporate Headquarters, Sales & Manufacturing:
Dabir Surfaces, Inc., 7447 West Wilson Ave., Harwood Heights, IL 60706, USA, www.dabir-surfaces.com
Sales Inquiries:
[email protected], Tel: +1(888)559-3641
Technical Support:
[email protected], Tel: +1(888)559-3642
PATENT:
www.dabir-surfaces.com/patents
Distributor (North America):
STERIS Corporation, Customer Service, Tel: +1(800)548-4873, Fax: +1(440)639-4450; Service Support, Tel: +1(800)333-8828
Authorized European Rep:
Emergo Europe, Prinsessegracht 20, 2514 AP The Hague, The Netherlands
DOC# R02-0006-00014-IA
2
MD
75%
933
HRS
933
HRS
MICROPRESSURE
933
HRS
HIGH
LOW
CYCLE
SPEED
SURFACE
System Starting
SW vXXX.X.XX
System Installation - Surface Connections
11. Insert surface connector as shown.
12. Listen for an insertion “CLICK” to confirm proper connection.
NOTE:
Session will start automatically if powered “ON”.
Surface
Connector
Controller Operation: “ON”, “OFF” and “PAUSE” Mode
13. POWER “ON”:
Touch and hold the “POWER” key until the “START-UP”
screen appears. Session will automatically begin if a Surface is connected.
Getting familiar with the Controller User Interface:
"UP ARROW"
Used to navigate
the menu display
"DOWN ARROW"
Used to navigate
the menu display and
change cycle speed.
"POWER"
"ON", "OFF" and "PAUSE"
"SELECT"
"MENU" confirmation and
"KEY LOCK" mode
STEPS 11 & 12:
Connector insertion
WARNINGS / CAUTIONS:
•
The Session is NOT provided unless the controller is powered “ON” and the surface is actively cycling.
Quick Set-Up Guide - Continued
16. “KEY LOCK” MODE “ON” / “O
FF”:
Touch and hold the "SELECT" key
for 4 seconds to “LOCK” display. (Yellow lock symbol will appear.)
Touch and hold the “SELECT” key for another 4 seconds to
“UNLOCK” the display. (Yellow lock symbol will disappear.)
14.
POWER “OFF”:
Touch and hold the “POWER”
key until the “OPTIONS” Menu appears. Select
“SHUTDOWN” by touching “POWER” key for 2
seconds.
15. “PAUSE” MODE:
Touch and hold the “POWER”
key until the “OPTIONS” screen appears, then
select “PAUSE” to temporarily stop the session.
(Default is 30 minutes.) Select “RESUME” at
anytime to immediately resume the session.
STEP 13:
Power controller “ON”
NOTE:
To change cycle speed on
Patient Care
™
models, press the “MICROPRESSURE” key
SELECT OPTION
SHUTDOWN
RESUME
PAUSE
(Hold 2 seconds)
RESUME
RESUME IN XX:XX MINUTES
SYSTEM PAUSED