Da-Lite PRO IMAGER, Инструкция, Страница: 3 / 8

FRAME ASSEMBLY
2
TOOLS REQUIRED FOR ASSEMBLY
5/16" socket or wrench
Carpenters level
Tape Measure
1. Unpack frame pieces and lay them face down on
the floor. The top frame has the roller and motor
assembly attached to it. The side frames are the
two short pieces.
2. Attach the side frame pieces to the top frame.
See figure 1. Insert the slat bar into the small
channel located on the side frame. Fasten the
frame pieces with four #10 x 3/4" hex head
screws.
NOTE: the top and bottom frame pieces will over-
lap the side frame pieces.
3. HORIZONTAL MASK ONLY - Attach the bottom
frame with four #10 x 3/4" hex head screws.
Attach the bottom brackets with the two screws
at the back of the frame as shown in figure 2.
VERTICAL MASK ONLY - Attach the pull straps to
the bottom slat bar by sliding the looped end of
the pull straps over the ends of the slat bar (See
figure 2 for pull strap attachment). The bottom
roller is spring loaded and has an internal lock to
keep it from retracting during shipping. To disen-
gage the lock pull on the slat bar to unroll the
mask but DO NOT let go of the slat bar. To lock
the roller let the mask retract slowly and the lock
will engage. The lock will only engage when the
frame is laying face down on the floor. When the
frame assembly is hanging on the wall the lock
will not engage. Insert the slat bar into the small
channel on the side frame. Fasten the bottom
frame with four #10 x 3/4" hex head screws.
Attach the bottom brackets with the two screws
at the back of the frame as shown in figure 2.
SLAT BAR
FIG. 1
CHANNEL
1/8" MAX.
PULL STRAP
GUIDE
PULL STRAP
SLAT BAR
VIEWING
SURFACE
FIG. 2
#10 x 3/4" SCREWS
BOTTOM
BRACKET
#10 x 3/4" SCREW