The Perm Wall frame should be fastened to a wall. The frame is not designed for “flying” installations.
1. Assemble frame sections together by inserting plastic corner brackets to tubes and securing the corners with #12
sheet metal screws. If you have a larger jointed frame, insert steel bracket on one section of frame into other section
matching the color code. Insert 10-32 screw through tube and bracket and fasten with wing nut.
NOTE: If the viewing surface is attached to the frame before the frame is secured to the wall, the frame may bow.
2. Place bottom of frame at desired height on wall. Make sure bottom is level. Drill through aluminum tubing every 18" to
24" and fasten to wall with appropriate fastener (not supplied) for type of wall construction.
NOTE: Use appropriate fastener for wall construction, i.e. wood screws if wall behind frame is wood construction or
other appropriate fastener if dry wall or plaster or cement block construction.
3. Make sure that sides are at 90 degrees or right angle to bottom and fasten to wall in like manner. Next fasten top of
frame to wall in the same manner, making sure that the center is the same distance from the bottom as it is at the
sides of frame. This is most important for proper surface fit.
NOTE: If a center spreader is shipped with frame, insert center spreader between the bottom and the top of frame as
a guide. This is most important to insure that the top and bottom are equal distance apart across the entire top of
frame. Lack of care in this regard will result in poor fit of surface. Center spreader can be removed once top of frame
is fastened to the wall.
4. Carefully snap surface onto frame. This completes the installation.
PERM WALL INSTALLATION
1
Printed in U.S.A.
76087 Rev. 4/08
Da-Mat
®
, High Contrast Da-Mat
®
, Pearlescent, Cinema Vision, High Contrast Cinema Vision, High Contrast Cinema Perf, Audio Vision,
High Contrast Audio Vision, Da-Tex
®
(Rear)
and
Dual Vision
surfaces can be cleaned as follows:
Using a white clean cloth (100% cotton preferred) that is dampened with clear water, gently wipe the area in one
direction. Do not use a circular motion. Using a dry 100% cotton cloth, wipe dry after each cleaning session. To clean a
stubborn stain or a sticky surface, use denatured alcohol (methanol or methyl alcohol) following the same procedure as
for water.
CLEANING
COLOR CODED
BANDS
TO SIMPLIFY
ASSEMBLY (FOR
LARGE SCREENS
WITH WIDTH 96"
AND OVER)
BINDING WITH
SNAP BUTTONS
PRECISELY
PLACED
STUDS FOR
SNAP
BUTTONS
WING NUT CONCEALED
BY BINDING
DETAIL VIEW OF
FRAME JOINT
CORNER PLASTIC BRACKET
ANODIZED
ALUMINUM FRAME
STEEL BRACKET
FRAME TUBING
PICTURE
SURFACE
FRAME
TUBING
#12 SHEET METAL
SCREW
DETAIL VIEW OF
FRAME CORNER
