Da-Lite Multi vision imager, Инструкция

Страница: 3 / 12

3
Multi Vision Imager Frame Assembly
1. The main frame pieces are individually paper wrapped and
taped. Remove all paper from the pieces.
Do Not Use A Utility Knife To Remove Paper
2. Lay frame pieces out on the floor or table as shown in
Figure 2. The top frame assembly has the roller, motor and
tensioned fabric attached to it. The right side frame assembly
has the junction box attached to it.
3. Assemble left side of frame to the top and bottom of frame.
The large L brackets will slide into the aluminum extrusion
while the small L brackets will slide into the aluminum
channel. Use #10 x 3/8" button head screws to attach parts.
See Figure 2.
4. Using an 1/8" Allen wrench tighten screws. Adjust screws
so that the front surfaces evenly match at the corners.
5. Assemble right side of frame to the top and bottom of frame.
This is done exactly the same way as the left side.
6. Insert motor phone RJ-45 jack into receptacle located
at the top of the junction box. Insert motor cable connector
to the connector located on the side of junction box.
7. Remove the shipping braces by removing #10 x 3/8" sheet
metal screws from the aluminum slat. Two of these screws
will be used later to “WALL MOUNT” screen to wall. Remove
black knobs and shipping braces. Carefully let the slat rest on
the inside of the top frame. Save the knobs, they will be used
to attach the Da-Snap frame to the main frame.
8. Carefully slide the Da-Snap frame inside the main frame as
per Figure 3. First, slide the bottom of frame under the
bottom bracket, then the top, under the top bracket(s). Make
sure the tensioned screen is not hit by the top of the Da-Snap
frame. Lift Da-Snap frame against the inside top and bottom
brackets, align holes and attach with black knobs.
At this point, preparations are needed to provide electrical power
to unit; see “ELECTRICAL INSTALLATION” and wiring diagrams
on pages 4 and 5.
Multi Vision Imager Assembly
Figure 2
Top Of Frame
Receptacle
Black Knobs (4)
Right Of Frame
Bottom Of Frame
Left Of Frame
Large L Bracket
Small L Bracket
#10 x
3
⁄
8
" Button
Head Screw
Shipping
Braces (4)
Phone Jack
Connector
Connector
Junction Box
Installation Hole
For
1
⁄
2
" Conduit
#10 x
3
⁄
8
" Sheet
Metal Screws (4)