![background image](http://html1.mh-extra.com/html/da-lite/multi-format-imager/multi-format-imager_instruction-book_3132051003.webp)
3
1. The frame will arrive in two separate cardboard boxes. One
box will be very long and will house the top & bottom pieces.
The smaller cardboard box will house the side frame pieces,
hanger hardware, hardware required to put frame together
and the wall switch.
2. To open the boxes there is a side flap that is taped down the
length of the box. It will be labeled OPEN THIS SIDE (Figure 1).
Carefully cut tape down the length of the box with a utility
knife and fold box open. You will have to tear hard on the
ends as it is stapled on the ends.
3. Inside each box the frame pieces will be individually paper
wrapped and taped. Remove all paper from pieces.
CAUTION: DO NOT USE A UTILITY KNIFE TO REMOVE
PAPER FROM PIECES
ATTENTION: N'UTILISEZ PAS DE COUTEAU UTILITAIRE
POUR RETIRER LE PAPIER DES PIÈCES.
4. Remove all paper and styrofoam blocks from top frame
assembly after unwrapping.
1. In the hardware bag, you will receive (12) #10 x .375" long hex
button head screws and (4) #10 x .500" long hex button head
screws required for frame assembly.
2. Lay frame pieces out on floor or table as shown in Figure 1.
The top frame assembly has the roller and motor assembly
attached to it. The side frames are the two shorter pieces.
Watch side piece to make sure oriented properly. The sides
have two riv nuts used for roller mounting brackets that
should face toward the top frame piece.
Unpackaging the Frame:
Frame Assembly
Rivnut
Make sure slat is
guided in to the
channel
Figure 1
Top of Frame
Bottom of Frame
Right of
Frame
Left of
Frame
Содержание Multi Format Imager
Страница 1: ...INSTRUCTION BOOK FOR Dual Format Imager...
Страница 11: ...11...