![background image](http://html1.mh-extra.com/html/da-lite/electrol/electrol_instruction-book_495272004.webp)
3
INSTALLATION
1. Level unit lengthwise with a carpenter’s plum level.
CAUTION! DO NOT COMPLETELY SEAL IN UNIT. ACCESS ROOM MUST BE ALLOWED FOR MOTOR REPAIR OR FABRIC
REPLACEMENT.
2. Remove shipping brace by removing 2 hex head screws (Figure 4).
3. Use supplied 1/8” nex key and a 5/16” wrench to remove silver shipping brackets attached to slat and screen case.
4. Remove wrapping paper.
CAUTION! DO NOT CUT WRAPPING PAPER WITH KNIFE OR ANY SHARP TOOL. REMOVE BY HAND.
5. Install electrical hook up that applies to your unit. Make sure to review your Electrical Installation Checklists and
wiring diagrams (included) for either 110 volt switch, 220/240 volt switch, or DRC low voltage control.
6. Test installation by carefully running surface up and down several times. Be prepared to stop screen.
NOTE: The picture surface, when rolled down, should have at least a full wrap and a half around the roller. Do not allow any
part of the roller to become exposed.
s
!
s
!
SLAT
FIGURE 4
SHIPPING BRACE
(NOT ON 4-1/2" ROLLER)