background image

There are three ways to install the Designer Contour

®

 

Manual: Wall Mount, Ceiling Mount, or Ceiling Hook. 
Procedures for each method are as follows:

Wall Mount

  1.  Secure the wall mount bracket to the wall at the 

desired height. Bracket should be fastened to wall 
studs or some reinforcement within the wall. 
Concrete or brick walls require special fasteners 
and anchors.

  2.  Make sure the bracket is level. See figure 1 for 

reference dimensions.

  3.  Keep in mind you will need at least 7/8" between 

the ceiling and the top of the wall mount bracket 
to be able to position the case on the bracket.

  4.  Mount the screen case on the wall bracket as 

shown in figure 1. Be sure the case is fully seated 
on the bracket. Tighten the stop screws against 
the wall bracket.

Ceiling Mount

  1.  Do not remove the wall mount bracket, even if 

you are not using it for mounting. This provides 
structural stability to the case.

  2.  Be sure the ceiling has adequate reinforcement to 

attach the screen brackets.

  3.  The top of the screen case has a channel that the 

ceiling mount brackets slide into. Loosen the two 
set screws on the brackets and slide bracket so it 
extends over the end of the case. Lock the 
brackets in place by tightening two set screws. 
Refer to figure 2. Mount cannot be more than 12" 
from end of case.

  4.  Hold the screen case up to the ceiling and mark 

the hole locations. Drill holes into the ceiling and 
attach screen with the appropriate fasteners for 
your ceiling.

SET SCREWS (2)

CEiLing 

MounT 

HoLES

FIGURE 2

FIGURE 1

4-1/4"

5/16"

9/16"

CaSE 

HooK

WaLL 

MounT 

BRaCKET

4-5/8"

SToP SCREW

1

You HaVE MaDE a WiSE SELECTion…
in choosing a Da-Lite projection screen designed and engineered to produce the sharpest, most pleasing 

pictures with maximum convenience.

PROTECT YOUR SCREEN

 by keeping it rolled in its protective case when not in use. always examine both front and back of 

surface before re-rolling into case to make certain screen is free of dust, dirt or other foreign matter. use a very soft 
duster brush gently to remove foreign particles.

Care in mounting and care in correct operation will mean a long and satisfactory life for your Da-Lite wall/ceiling screen. 
Locate the screen where the audience can best see it and where other furnishings in the room permit. Mount the screen 
so that bottom of picture surface, when fully extended, will be above heads of viewers.

INSTALLATION

Содержание DesIgner Contour Manual

Страница 1: ...troit Street Post Office Box 137 Warsaw Indiana 46581 0137 Phone 574 267 8101 800 622 3737 Fax 574 267 7804 Toll Free Fax 877 325 4832 www da lite com e mail info da lite com Instruction Book for Designer Contour Manual The Da Lite Difference ...

Страница 2: ...screws on the brackets and slide bracket so it extends over the end of the case Lock the brackets in place by tightening two set screws Refer to figure 2 Mount cannot be more than 12 from end of case 4 Hold the screen case up to the ceiling and mark the hole locations Drill holes into the ceiling and attach screen with the appropriate fasteners for your ceiling SET SCREWs 2 ceiling mount holes FIG...

Страница 3: ...at screwdriver to turn the adjustment knob on the right end of the screen see figure 2 or 3 To increase the travel speed turn counterclockwise To decrease the travel speed turn clockwise Adjustments should be made in half turn increments and travel speed checked before adjusting further If screen locks at the bottom and will not retract turn adjustment knob one quarter turn counterclockwise SCREEN...

Страница 4: ...to your Da Lite dealer If it is necessary for the dealer to return the screen or part to Da Lite transportation expenses to and from Da Lite are payable by the purchaser and Da Lite is not responsible for damage in shipment To protect yourself against damage or loss in transit insure the product and prepay all transportation expenses THIS WARRANTY IS IN LIEU OF ALL OTHER WARRANTIES EXPRESS OR IMPL...

Отзывы: