![background image](http://html1.mh-extra.com/html/da-lite/da-snap-screen/da-snap-screen_instruction-book_495251005.webp)
5
Method 3 (Screens Over 96"
In Viewing Width)
Method 4 (High Power® Fabric)
Cleaning
1. Use the supplied #10 screws to attach six frame brackets to the
back of the frame as shown in Figure 8.
2. Secure the wall brackets to wall studs at the desired height. Make
sure the brackets are level. The top of the frame will be 1/8" above
the top of the wall bracket when mounted. You will need at least
5/8" clearance above the bracket to hang the screen.
3. To install the lower wall bracket, you must measure the overall
height of the screen frame and subtract 1/4". This is the
dimension from the top of the upper wall bracket to the bottom
of the lower wall bracket. See Figure 6.
4. For 150", 180", 200", 220" and larger screens with 2-piece side
frame rails you will need to attach one High Power® bracket to
each side frame rail. Use the black #10 screws supplied.
See Figure 8.
5. Unroll the screen on a clean surface. Do not use newspaper. The
viewing side is rolled to the inside of the roll. Place the frame over
the screen surface, and while lifting the frame with one hand,
snap the screen surface onto the frame with the other hand
while maintaining a steady pull on the surface.
6. Position the screen with the attached surface onto the top wall
bracket as shown in Figure 7. Push down at the center of the
bottom frame rail to hook onto the lower wall bracket.
7. If you attached brackets to the side frame rails in step 4,
anchor these to the wall with an appropriate fastener for
your type of wall.
1. Use the supplied #10 screws to attach two frame brackets and
two High Power® brackets to the back of the frame as shown in
Figure 9.
2. Secure the large wall bracket to wall studs at the desired height.
Make sure the bracket is level. The top of the frame will be 1/8"
above the top of the wall bracket when mounted. You will need
at least 5/8" clearance above the bracket to hang the screen.
3. Unroll the screen on a clean surface. Do not use newspaper.
The viewing side is rolled to the inside of the roll. Place the frame
over the screen surface, and while lifting the frame with one
hand, snap the screen surface onto the frame with the other
hand while maintaining a steady pull on the surface.
4. Position the screen with the attached surface onto the top wall
bracket as shown in Figure 7. Push down at the center of the
bottom frame rail to tension the fabric. Mark the screw holes
for the bottom brackets. Drill holes in wall and attach the
brackets to the wall with screws.
Da-Tex®, Dual Vision, Pearlescent, Cinema Vision, High
Power®, Da-Mat®, High Contrast Da-Mat®, Audio Vision, High
Contrast Audio Vision, High Contrast Cinema Vision
and
High
Contrast Cinema Perf
surfaces can be cleaned as follows:
Using a white clean cloth (100% cotton preferred) that is
dampened with clear water, gently wipe the area in one direction.
Do not use a circular motion. Using a dry 100% cotton cloth,
wipe dry after each cleaning session. To clean a stubborn stain
or a sticky surface, use denatured alcohol (methanol or methyl
alcohol) following the same procedure as for water.
Figure 9
Frame Brackets
2-Pieces
#10 Screws
8-Pieces
Large Wall
Bracket
1-Piece
High Power® Bracket
2-Pieces
Figure 8
Frame Brackets
6-Pieces
#10 Screws
12-Pieces
Large Wall
Brackets
3-Pieces
High
Power®
Bracket For
Large Split
Frames,
And 150",
180", 200"
And 220"
Diagonal
Screens.
2-Pieces