Da-Lite Da-Snap 74610, Инструкция

Страница: 5 / 6

4
INSTALLATION
5. Unroll the screen on a clean surface. Do not use
newspaper. The viewing side is rolled to the
inside of the roll. Place the frame over the screen
surface, and while lifting the frame with one
hand, snap the screen surface onto the frame
with the other hand while maintaining a steady
pull on the surface.
6. Position the screen with the attached surface
onto the top wall bracket as shown in figure 7.
Push down at the center of the bottom frame rail
to hook onto the lower wall bracket.
7. If you attached brackets to the side frame rails in
step 4, anchor these to the wall with an
appropriate fastener for your type of wall.
Method 4
1. Use the supplied #10 screws to attach two frame
brackets and two High Power brackets to the
back of the frame as shown in figure 9.
2. Secure the wall bracket to wall studs at the
desired height. Make sure the bracket is level.
The top of the frame will be 1/8" above the top of
the wall bracket when mounted. You will need at
least 5/8" clearance above the bracket to hang the
screen.
3. Unroll the screen on a clean surface. Do not use
newspaper. The viewing side is rolled to the
inside of the roll. Place the frame over the screen
surface, and while lifting the frame with one
hand, snap the screen surface onto the frame
with the other hand while maintaining a steady
pull on the surface.
4. Position the screen with the attached surface
onto the top wall bracket as shown in figure 7.
Push down at the center of the bottom frame rail
to tension the fabric. Mark the screw holes for
the bottom brackets. Drill holes in wall and attach
the brackets to the wall with screws.
CLEANING
Da-Tex, Dual Vision, Pearlescent, Cinema Vision, High
Power, Da-Mat, High Contrast Da-Mat, Audio Vision, High
Contrast Audio Vision, High Contrast Cinema Vision
and
High Contrast Cinema Perf surfaces can be cleaned as
follows:
Using a white clean cloth (100% cotton preferred)
that is dampened with clear water, gently wipe the
area in one direction. Do not use a circular motion.
Using a dry 100% cotton cloth, wipe dry after each
cleaning session. To clean a stubborn stain or a
sticky surface, use denatured alcohol (methanol or
methyl alcohol) following the same procedure as for
water. For extremely stubborn stains, use V M & P,
Naphtha or Super Naphtha and follow the same
procedure as for water.
FIGURE 9
FRAME BRACKETS
2-PIECES
#10 SCREWS
8-PIECES
WALL BRACKET
1-PIECE
HIGH POWER BRACKET
2-PIECES