Da-Lite Da-Lift Series, Инструкция

Страница: 3 / 8

3
1. Mounting Da-Lift Projector Lift between joists.
Install the joists at the proper height and width to fit the Da-Lift
you are installing. See Figure 1.
NOTE:
The Da-Lift must be installed on top of the joists.
Be sure to leave access from above for installation.
When the joists are properly installed, and secured in place, slide
the Da-Lift in position. Bolt the two brackets (38mm x 483mm)
to the frame. Lower the unit onto the joists and secure in place.
Additional bracing may be required, based on construction.
NOTE:
Da-Lift projector lift must be installed level!
Suggested Method of Installation
Figure 1
Figure 2
Model
Lifting
Capacity
Width
A
Height
B
Depth
C
Height
D
Dim.
E
Dim.
F
Da-Lift 10M 9.0N 575mm 381mm 559mm 114mm 613mm 356mm
Da-Lift 15M 9.0N 575mm 508mm 559mm 241mm 613mm 356mm
Da-Lift 15 67.4N 781mm 508mm 864mm 241mm 819mm 413mm
Da-Lift 19 67.4N 832mm 610mm 965mm 343mm 870mm 413mm
Da-Lift 19L 67.4N 1086mm 610mm 1219mm 343mm 1124mm 413mm
2. Mounting Da-Lift Projector Lift using threaded rods.
Secure four threaded rods to the ceiling at the dimensions
shown. See Figure 2, “E” and “F”. Install the mounting bracket
(38mm x 483mm) to each side of Da-Lift with 1/2” diameter bolts,
flat washers and nuts. Attach one nut on each rod and run the
nut up to the desired height.
Slide Da-Lift projector lift up with all (4) four threaded rods into
the mounting brackets. Install nuts under the mounting brackets.
Adjust the frame to the proper height and level with bottom nuts
on the rod. Lock the mounting brackets in place with the nuts on
the top of each rod. Frame must be level and solid. Additional
bracing may be required, based on construction.
C
B
D
E
A
F