D-Teg TX4000B, Руководство пользователя

Страница: 9 / 48

9
FUNCTIONS
G-Sensor Calibration
1. Set G-Sensor Axis using the configuration tool.
2. “selfadj.ini” should be in the config folder of the SD card.
3. Install the unit and park the vehicle on a flat surface .
4. Turn on the unit and wait until it start record.
5. Press and hold the “M1” button more than 2 seconds.
6. You will hear “beep” when you press “M1” button and then you will hear
another “beep” after 2seconds. Then release “M1” button.
7. Then calibration will be done within 2 seconds.
Built-in power backup (Super Capacitor)
When power to the unit is interrupted, TX4000 creates the last
file using the internal Super Capacitor.
Time and Date
Set your time zone using the configuration tool then TX4000 get’s time from the
GPS satellite's.
SD Memory Card Format
Please format [initialize] the SD card using the “Configuration Tool TX4000”
software.
G-Sensor Calibration is needed after installing the TX4000.
Power off vehicle and take out SD memory card
Turn off the power and then check the BLUE LED light. Once the LED light
is not on, you can now safely remove the SD memory card.
Safely Removal SD Card