Document Number:
V013421_05_MiniRad-V_Manual_Installation_Instructions
Date:
8/28/2019
Page:
6 of 13
D-tect Systems
•
11814 South Election Rd. Suite 200, Draper, UT 84020
•
(801) 260-4000
5.3 In-Cab Display Module Installation
The In-Cab Display module should be placed within easy reach of the operator and should be attached
securely to a solid surface. The module is attached to a support that is secured by three ¼” screws spaced 1
¼” apart. Make sure that the In-Cab Display module does not block the view of the driver or interfere with
vehicle controls and/or other equipment.
Contact your local Department of Transportation for information regarding regulations for dashboard-
mounted displays, as these may vary from state to state. The In-Cab Display module must be connected to
the External Detector module via the communication cable. Depending on the vehicle model and
configuration, this cable can usually be run under the dashboard and through the engine compartment.
Figure 6: In-Cab Display Module
•
Place inside the cab where it is visible
from inside the vehicle but does not
obscure the driver’s view.
•
Make sure the cable reaches from one
unit to the other before firmly securing
either unit.
